How do you remove a rear fender on a Harley Davidson?
Have a safe place prepared where you can set the fender after it is removed from the motorcycle. It is best to remove a Harley Davidson rear fender as a complete assembly. Unplug any wiring. If your motorcycle has an ECM, remove the plastic pin that retains the plastic pocket. This should stay with the motorcycle.
How do you get a tip light out of a Fender?
Discussion in ‘ Electrical ‘ started by semperfire, Oct 4, 2011 . Trying to take fenders off. The tip lights have a plug connector. When looking at OEM parts it shows that the wire can be pulled from the plug connector in order to snake the wire back out of the fender How do you get the wiring out of the plug connector.
How do you take a tip light off a Harley Davidson?
Trying to take fenders off. The tip lights have a plug connector. When looking at OEM parts it shows that the wire can be pulled from the plug connector in order to snake the wire back out of the fender How do you get the wiring out of the plug connector. There is a little hatch that flips up to expose it.
Have a safe place prepared where you can set the fender after it is removed from the motorcycle. It is best to remove a Harley Davidson rear fender as a complete assembly. Unplug any wiring. If your motorcycle has an ECM, remove the plastic pin that retains the plastic pocket. This should stay with the motorcycle.
What do you put on a street Bob Fender?
To finish things off we installed a blacked-out LED taillight with internal turn signals from our dude Steve at Speed-Kings Cycle. Here’s how it all went. Step 1: We removed the stock bobbed fender from the bike via the four bolts fastened to the frame rails.
Do you like the fenders on a Dyna Street Bob?
We like them on some bikes and others we don’t. Such is the case with the Dyna Street Bob. The bike is great from the factory with all its muted colors and parts pick, but that rear fender always has us longing for something, well, a bit longer.
How do you remove a stock Fender from a bike?
Step 1: We removed the stock bobbed fender from the bike via the four bolts fastened to the frame rails. Step 2: Along with it came all of the OEM lighting and ugly right-side license-plate holder. Step 3: As you can see, the longer fender will do a much better job keeping debris off the rider and bike than the stock bobbed unit did.
How do you remove the rear fender on a Harley Davidson?
Evenly loosen all of the Harley rear fender strut hardware then remove the two forward most strut bolts that screw directly into the motorcycle’s frame. Next, remove the strut bolt that is secured through the rear frame horn.
To finish things off we installed a blacked-out LED taillight with internal turn signals from our dude Steve at Speed-Kings Cycle. Here’s how it all went. Step 1: We removed the stock bobbed fender from the bike via the four bolts fastened to the frame rails.
We like them on some bikes and others we don’t. Such is the case with the Dyna Street Bob. The bike is great from the factory with all its muted colors and parts pick, but that rear fender always has us longing for something, well, a bit longer.
Step 1: We removed the stock bobbed fender from the bike via the four bolts fastened to the frame rails. Step 2: Along with it came all of the OEM lighting and ugly right-side license-plate holder. Step 3: As you can see, the longer fender will do a much better job keeping debris off the rider and bike than the stock bobbed unit did.