How do you put a trickle charger on a motorcycle?

How do you put a trickle charger on a motorcycle?

How to Use a Trickle Charger on Your Motorcycle Battery

  1. Take a Close Look First.
  2. Set the Charger’s Values.
  3. Remove the Battery From the Bike.
  4. Pick the Charging Location.
  5. Ground the Charger.
  6. Connect the Cables.
  7. Power up the Charger.
  8. Check on the Setup.

How often should I charge my Harley battery?

Battery Myth | How Often Should I Charge My Motorcycle, ATV or Boat Battery? Any type of lead acid battery should always be left in a fully charged condition. Having done that, you should either charge your battery every 30 days or so, or consider getting a smart charger to maintain your battery all the time.

How long do Harley motorcycle batteries last?

While the ultimate life of a motorcycle battery is determined by many factors, according to Harley-Davidson a well-maintained battery should deliver at least five years of service.

Where does the charge lead go on a Harley Davidson?

The battery charge lead runs form the voltage regulator to the positive side of the battery. The AC output lead wire leads from the voltage regulator to the stator.

Can a battery be over charged on a Harley Davidson?

If you plug the tender in between rides and while the bike is stored, the battery will remain charged and ready. Harley-Davidson branded battery tenders are designed not to overcharge the battery and not to allow a deep charge, where the battery is allowed to drain almost entirely.

How big of a charging system do you need for a Harley Davidson?

We would suggest upgrading to at least a 32 amp charging system. It doesn’t sound like your charging system is functioning at 100 percent. Often, with age, grounds become an issue. Also, corrosion on pins & sockets. Especially on a model such as yours that has so many options.

How do you close the battery on a Harley Davidson?

This modal can be closed by pressing the Escape key or activating the close button. Unless you have a kick-start, you’ll need a battery to get your Harley started and to keep it functional. With that can come some Harley Davidson charging problems. Bob shares some tips on battery replacement and upkeep.

The battery charge lead runs form the voltage regulator to the positive side of the battery. The AC output lead wire leads from the voltage regulator to the stator.

Where can I get a new Harley Davidson battery?

Choose the best Harley-Davidson battery for your bike at BatteryStuff.com; we have the largest selection of batteries for Harley Davidson’ and other motorcycles. Replaces: YHD-12, 6607-84 (AGM upgrade!) Replaces: YTX20HL, YTX20HL-BS, YTX20L-BS, hYTX20DHL, HVT-1, Harley Davidson # 65987-…

What should the voltage be on a Harley Davidson battery?

Turn the ignition and start the bike. The volts should not drop below 9.6 volts when the starter engages. Turn the throttle to rev the engine. As the engine is revved, the volts should go up to 13 or 14 volts. Identify the wires. The battery charge lead runs form the voltage regulator to the positive side of the battery.

How does a Harley Davidson battery charger work?

The built-in smart circuitry cycles the charger to turn itself on and off as needed, so your battery never overcharges. • Includes a quick-disconnect 7.5 Amp fused Battery Charging Harness with ring terminals that can attach to the battery screw terminals for easy connection, and a 7.5 Amp fused alligator clip charging harness