How do you program a 2006 Toyota rav4 key?
Programming Instructions:
- Begin with the key out of the ignition.
- OPEN and UNLOCK the DRIVER’S side door.
- Within 5 seconds INSERT the key into the ignition and PULL it out TWICE.
- CLOSE then OPEN the DRIVER’s side door TWICE.
- Insert key INTO the ignition then REMOVE it.
- CLOSE then OPEN the DRIVER’s side door TWICE.
How do you program a transponder chip?
How to Reprogram a Transponder Key
- Enter your vehicle and put the key into the ignition and turn it to the “ON” position. Leave it in for 10 minutes and 30 seconds.
- Before 45 seconds pass, turn the key to the “OFF” position.
- Repeat the above step by turning the key to the “OFF” position within 45 seconds.
How do you program the transponder on a Toyota?
Now that you have the newly cut key and the master key, you can program the Toyota transponder key. Sit in the driver’s side of the Toyota vehicle. Press and release the brake and gas pedal simultaneously. Insert the master transponder key. Do not turn it.
How to program a new key for a Toyota RAV4?
Open and close the driver’s door 6 times, then remove the original key and transponder and insert the key to be programmed. 3. The alarm light will be slowly blinking for a minute or so, when it stops, remove the new key as it is programmed. 4.
How do you change the transponder key in a car?
Insert the newly cut transponder key into the ignition, but do not turn. Press the gas pedal once. Wait up to 2 minutes or whenever the security light on the dashboard turns off. Once the light goes off, remove the new transponder key and press the brake pedal once. The new transponder key should now be programmed.
Can a master key be used to program a transponder?
I have tried many times to program a new transponder key using the (5x ign key 6 door closes) using a master key and it will not go into the program mode. That is where the red light stays on indicating it is in the program mode. This technique is all over the net but won’t work for me.