How do you program a 2006 Pontiac Key?
How to Program a Pontiac Ignition Key
- Enter your car and insert your key into the ignition.
- Cycle the key in the ignition to the “On” position and leave it in that position for 10 minutes and 30 seconds.
- Cycle the key back “Off” within 45 seconds.
Does a 2006 Pontiac G6 have a chip key?
NOTE: This ignition key has a chip hidden inside of the plastic head. It is a part of your automobile security system to prevent theft. Therefore, you MUST get it both: cut and programmed. Cutting only will NOT allow you to start the engine.
How to program the ignition key on a Pontiac?
Cycle the key in the ignition to the “On” position and leave it in that position for 10 minutes and 30 seconds. Cycle the key back “Off” within 45 seconds. Repeat Steps 2 and 3 two more times, and then cycle the key back to the “On” position. Hold the key in the “On” position for five seconds, and use the key to start the car to end the process.
Is it possible to program an ignition switch?
These keys are synced with your engine to start your car, and once you program them, only a programmed key will start your car. Both safe and convenient, you can program the key to the switch in just a few minutes from your car’s driver’s seat. Enter your car with your cut ignition key and insert the key into the ignition switch.
How long does it take to turn off the ignition on a Pontiac?
Cycle the key back “Off” within 45 seconds. Repeat Steps 2 and 3 two more times, and then cycle the key back to the “On” position. Hold the key in the “On” position for five seconds, and use the key to start the car to end the process.
How do you replace an ignition switch on a car?
Installing a Replacement Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module. Slide the ignition switch into its hole.
Cycle the key in the ignition to the “On” position and leave it in that position for 10 minutes and 30 seconds. Cycle the key back “Off” within 45 seconds. Repeat Steps 2 and 3 two more times, and then cycle the key back to the “On” position. Hold the key in the “On” position for five seconds, and use the key to start the car to end the process.
These keys are synced with your engine to start your car, and once you program them, only a programmed key will start your car. Both safe and convenient, you can program the key to the switch in just a few minutes from your car’s driver’s seat. Enter your car with your cut ignition key and insert the key into the ignition switch.
Cycle the key back “Off” within 45 seconds. Repeat Steps 2 and 3 two more times, and then cycle the key back to the “On” position. Hold the key in the “On” position for five seconds, and use the key to start the car to end the process.
How to replace the ignition switch on a GM car?
1. Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops flashing. 2.