How do you perform a basic drive cycle?
Here are step-by-step instructions on how to perform a basic, yet very effective, drive cycle that will complete the readiness monitors for your vehicle’s emissions control system. Have the fuel tank between 30 and 70 percent full. Some systems, especially the EVAP system, need to have a specific level of fuel in order for the tests to be trusted.
How to pass inspection and complete a drive cycle?
In this video I’ll show you how to complete a drive cycle and pass inspection after turing off your check engine light. It is true that your car will not pass inspection if the check engine light is on. However there is more to it than simply turning it off.
What do I need to know about the OBD-II drive cycle?
Gently coast the vehicle to a stop. Allow the engine to idle for 2 minutes and view WDS “PURGE VAPOR MANAGEMENT VALVE – DUTY CYCLE”, “CANISTER CLOSE VALVE – VAPOR RECOVERY SYSTEM”, and FUEL TANK PRESSURE – VAPOR RECOVERY SYSTEM”. WDS should give an indication that the test is active.
When to follow the Toyota recommended drive cycle?
That’s why it’s important to follow the Toyota recommended drive cycle after performing actions that are known to clear your Toyota’s computer memory. Remember, all on-board diagnostic monitors are cleared when the battery is disconnected, or when the powertrain control module (PCM) is cleared with a scan tool.
What do you need to know about a drive cycle?
Let the vehicle sit for more than 8 hours. The first step of the drive cycle is a cold start. In order for the test to begin, the engine temperature needs to match the outside ambient temperature. It’s also important to keep the vehicle in a temperature-controlled area. Double check the keys and doors.
How to perform a basic drive cycle-repairpal?
The Drive Cycle and Emissions Readiness Monitors have, for the most part, stopped this unethical tactic. Here are step-by-step instructions on how to perform a basic, yet very effective, drive cycle that will complete the readiness monitors for your vehicle’s emissions control system.
What are the requirements for an OBDII driving cycle?
To perform an OBDII Driving cycle do the following: Cold Start. In order to be classified as a cold start the engine coolant temperature must be below 50°C (122°F) and within 6°C (11°F) of the ambient air temperature at startup. Do not leave the key on prior to the cold start or the heated oxygen sensor diagnostic may not run.
How to check the drive cycle on a Honda?
The Honda Drive Cycle is included in recent owners manuals. You can either use an OBDII scanner or, if one is not available, check the MIL (check engine light) because Honda/Acura will indicate, on vehicle startup of the readiness monitors are set. When you turn the ignition to On-2 without starting the engine, the MIL will come on for 20 seconds.