How do you measure a snowmobile clutch offset?
Like the other guys said, lay a straight edge on the back of the secondary sheave, so that the length of it reaches out towards the primary. From that edge (of the straight edge) to the back of the sheave on the primary is the offset measurement.
How do you use clutch alignment bar?
First, insert the tool into the clutch disc. Make sure the clutch is facing the correct direction. The tool should stick all the way through the spines on the disc. Then place the clutch on the flywheel, and engage the alignment tool into the pilot bushing or bearing in the center of the crankshaft.
How tight should your snowmobile belt be?
Put a straight edge between the clutches and pull down on the center of the belt. The proper adjustment for the snowmobile shown in the video is 1 1/4″ of space between the straight edge and belt. The belt deflection on the belt, however, is about 1 1/2″, meaning it’s too loose and requires adjustment.
What kind of clutch does Arctic Cat use?
Arctic Cat clutches a notorius for the clutch pins and bushings wearing quickly. I compleetly rebuilt the primary on my Arctic Cat this winter (bushings, pins, spring) and after 800 miles I had to rebuild it again because the bushings egged out and the weights shifted and chewed the spyder.
What are the alignment measurements on Arctic Cat snowmobile?
The two alignment measurements are center to center (from the center of the primary clutch bolt to the center of the secondary clutch bolt) and off set (the distance between the outside of the inside secondary sheave, and the outside of the inside primary sheave……if you can follow that [] )
Do you need Stage 3 work on Arctic Cat mudpro clutches?
Spacer sleeve modification. The stage 3 work is necessary on arctic cat mudpro clutches, and is also necessary for any stage above stage 3. If you plan on a stage 5 setup, stage 3 is a must to get the proper belt alignment after stage 4. Complete lightening of the secondary clutch.
How to check the alignment of the clutch belt?
The belt performed flawlessly and looks like new. to check the engine alignment you put something straight (!) along the back of the clutches, holding it firm to the sec clutch and measure the distance from the prim clutch to your straight edge. First at the front of the prim clutch, then at the back.