How do you jumpstart a motorcycle starter?
How to jump-start a motorcycle using a portable jump starter
- Attach the positive clip (red) to the positive battery terminal.
- Attach the negative clip (black) to a metal surface on your bike.
- Turn on the portable jump starter; confirm it’s set to the correct voltage for your battery (12 volts for most motorcycles).
Where is the battery on a Sportster 1200 low?
Consequently, removing the battery from a Sportster 1200 Low is a slightly more complicated procedure than it is with most other motorcycles. Remove the black plastic cover for the battery compartment. The cover is located underneath the seat on the left side of the bike. Remove it by gently pulling on the top of the cover to unsnap its top clip.
When to remove the battery from a Harley Sportster?
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike.
Can you remove the negative terminal on a Sportster?
Remove the bracket connecting the negative (“-“) terminal to the frame of your Sportster with a socket wrench. The negative terminal grounds the battery. Removing it first will allow you to remove the wires connecting the positive (“+”) terminal without shocking yourself.
Where is the battery located on a Harley Davidson?
While removing the battery from most motorcycles requires you to simply access the battery compartment below the bike’s seat and disconnect the terminal wires, Harley Sportster 1200s designed the battery compartment such that the negative terminal is directly connected to the bike’s frame.
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike.
Where is the negative battery on a Harley Davidson?
Unfortunately, the negative cable is to the right side of the bike behind the oil tank. It’s a bit of a tight fit and, on some models, it may be necessary to pull the battery as far to the left as possible to access the negative terminal. If there’s not enough slack in the cables to reach it,…
What happens if you remove positive cable on Harley Davidson?
If you remove the positive cable first, you risk causing a dangerous spark if the battery comes in contact with your bike’s frame. Bob has been dealing with these batteries for years and removes the neg from the battery.
What happens when you disconnect the battery on a Harley Davidson?
The alarm has an internal battery of its own and disconnection of the main battery is one of the triggers that will cause it to sound. With the ignition switch in the RUN position, and the fob within range, the alarm is canceled. Once the fuse is removed, you can leave the switch in the run position until you’re finished with the job.