How do you install fog lights on a triumph?
First, get behind the front wheel and remove the two screws in each of the plastic panels on either side of the radiator. Triumph calls these the lower radiator infill panels. Next remove the single screw on the side of that panel, then pull the panel to the rear to remove it. Set it aside where you won’t step on it.
Where are the auxiliary lights on a jeep?
Therefore the E-series can be used as an auxiliary high beam while on the freeways. The E-series light (with 12 LEDs) puts out 5,280 lumens while pulling just 2.85 amps and 41 watts. These 6-inch-wide lights, being street legal, were perfect for mounting just above the cowling and below the windshield on the Jeep’s A-pillar.
What are the fog lights on a jeep?
These fog lights pretty much saved our trip when we hit a blizzard on I-70 near Aspen by providing a low angle beam pattern with minimal reflection. We were one of the few vehicles still able to drive in the snow because of the Jeep’s four-wheel drive and these fog lights.
How do you install a fog light on a car?
Insert the bolt. Thread the washer and nut over the bolt, tightening with a ratchet or wrench. Do not over tighten as you may damage the fog light housing or the vehicle. The housing should be snug and immobile. Reattach the switch. Reconnect the fog light switch using the clip.
What are the restrictions on installing fog lights?
Check your local laws. Some areas have restrictions on the type and color of lights you can install. Check your local regulations to make sure that your new lights are in compliance. Not all fog lights are approved for road use by the Department of Transportation.
Do you have to drill new holes for fog lights?
If it does not, you may have purchased the incorrect headlights. Make sure that the bolt holes line up; otherwise you may have to drill new ones. Insert the bolt.
What kind of light bulbs do you need for fog lights?
Some areas have restrictions on the type and color of lights you can install. Check your local regulations to make sure that your new lights are in compliance. Not all fog lights are approved for road use by the Department of Transportation. Choose your bulb type. There are three main types of bulbs available for fog lights.