How do you install a kill switch on a Honda Accord?
The advantage of installing a kill switch is that it acts like an anti-theft device in the form of a mechanical failure.
- Step 1 – Disconnect battery and remove rear seat cushion.
- Step 2 – Cut the power to the fuel pump.
- Step 3 – Connect switch to the fuel pump.
- Step 4 – Connect kill switch to the ignition circuit.
Can a Kill Switch be installed on a Honda Civic?
Adding a kill switch is a cheap and simple modification that can prevent thieves from driving away with your car. This guide will help you through the process of installing one to your Honda Accord or Civic. This article applies to the Honda Accord (1990-2002), and Civic (1992-2000).
Where do I put the Kill Switch on my car?
To install this on your car, you will need to go under the car and find the fuel line.
What kind of wire does a Honda kill switch use?
Cut the black and yellow 12-volt wire. If you are unsure which is the correct wire, you can use a voltmeter to find the 12-volt wire. You will need to reconnect the battery to do so. Strip two ends of a new wire.
How do you put a fuel cut off switch on a car?
Adding an inline fuel cut-off switch is a fairly straight forward way of physically stopping the flow of gas to your engine. To install this on your car, you will need to go under the car and find the fuel line.
Adding a kill switch is a cheap and simple modification that can prevent thieves from driving away with your car. This guide will help you through the process of installing one to your Honda Accord or Civic. This article applies to the Honda Accord (1990-2002), and Civic (1992-2000).
Cut the black and yellow 12-volt wire. If you are unsure which is the correct wire, you can use a voltmeter to find the 12-volt wire. You will need to reconnect the battery to do so. Strip two ends of a new wire.
To install this on your car, you will need to go under the car and find the fuel line.
How do you wire an ignition kill switch?
By using a wiring diagram for your car, you should be able to find which wire is your ignition cable and determine the proper one to cut into. Once the wire is cut, you can either solder the 2 ends of the wire into the switch, or use additional connectors and crimp it on (no soldering required). Below is an ignition kill switch wiring diagram: