How do you install a cruise control switch?
Do not allow the electrical connector to fall back into the steering wheel. 2. Disconnect the electrical connector and remove the switch. Install The Cruise Control Switch 3. To Install the new cruise control switch, reverse the removal procedure. Programming The Vehicle – Gasoline Engines NOTE: There may be a 5-10 second delay in IDS screens.
How does a command cruise control system work?
Fitting a Command Cruise ControlTM employs similar technology to provide a safer, more relaxed, and possibly less expensive journey. Supplied as a complete kit with a pad style control switch that mounts on the dashboard of the vehicle.
How to install cruise control on Ford 2011?
2011-C F-Super Duty Cruise Control 1 Page 1 o 2 SKBC3-A1-AA Copyright Ford 2011 FooCo Do not allow the electrical connector to fall back into the steering wheel. 2. Disconnect the electrical connector and remove the switch. Install The Cruise Control Switch 3. To Install the new cruise control switch, reverse the removal procedure.
What to do if your cruise control fails?
If the cruise control system fails to maintain the set speed, check the throttle linkage adjustment. Use your service manual for the correct procedure for adjusting the linkage. If the linkage is properly adjusted, check for vacuum leaks at the servo. Turn the engine of if turned on, and use jumper wires to energize the servo solenoid valves.
How to set cruise control on a car?
1 Start a new session and ID the vehicle. 2 Select — “Tool Box”, then select the following: “Module Programming” — “Programmable Parameters” — “Speed Items”. 3 Select — “Cruise Control Switch – (SCMM)” and set to “Enabled”. 4 Select — “Speed Control – (BdyCM)” and set to “Enable”.
What are the problems with a cruise control system?
by Paul Vaughn. The most common problem with cruise control systems is failure to engage and failure to maintain a set speed. Depending on the year and model of the vehicle, special tools such as a volt meter and vacuum tester may be needed for diagnosing the problem.
What to do if your Cruise Control is inoperative?
Apply vacuum using the hand held vacuum pump. If the servo fails to hold vacuum, replace it with a new part. This part can be purchased at your local part store or dealer. If both tests are good, this means that the cruise controller is inoperative and must be replaced. This part can also be found at your local parts store or dealer.
Where is the fuse box on a cruise control?
Locate the fuse box under the driver’s console. It has a plastic cover that can be removed . Check the inside diagram to determine which fuse you need to check. Probe both sides of the fuse. If one or neither lights the test light, the fuse is defected and replace.