How do you fix a transmission line rupture?
Cut the transmission line on both sides of the rupture using a circular tubing cutter. Clean both ends of the line thoroughly with #400 emery paper. Ream the inside walls of the cut transmission lines with a reamer. Apply light pressure to remove any burrs caused by the tubing cutter.
How to fix a radiator line leak in a transmission?
Park the car on a flat, solid surface. Place wheel chocks behind and in front of the rear tires to prevent the car from rolling. If ramps are to be used, put chocks in place immediately after the vehicle is secure on the ramps.
How to remove the lower control arm on a tdiclub?
The front bushing is held in with an 18mm bolt right behind the automatic transmission pan. I had to use an open ended wrench to loosen it, and then when I try to pull the bolt out, i pull it into the ATF pan, and I’m like… uh… I’m -not- going to change my ATF just to replace this bushing.
How do you remove the lower control arm?
Remove the dog bone mount. Then remove the battery and all associated hardware. Under the battery are 3/4bolts that hold the trans mount to the cradle. Don’t remove the long trans mount bolts as they are TTY bolts.
How do you remove transmission lines from a Chevy truck?
Crawl underneath the truck and follow the transmission lines back to the transmission, unbolting them from their mounting points on the frame using a 3/8-inch ratchet and socket. Then disconnect the lines from the transmission using the line wrenches.
The front bushing is held in with an 18mm bolt right behind the automatic transmission pan. I had to use an open ended wrench to loosen it, and then when I try to pull the bolt out, i pull it into the ATF pan, and I’m like… uh… I’m -not- going to change my ATF just to replace this bushing.
Where are the transmission cooler lines on a Chevy truck?
On a Chevrolet truck or car running a V6 or V8 engine, a set of transmission cooler lines typically runs from the front of the vehicle by the radiator into the transmission. This small radiator helps to cool the transmission fluid in the same way the radiator drops the temperature of coolant for the engine.
Remove the dog bone mount. Then remove the battery and all associated hardware. Under the battery are 3/4bolts that hold the trans mount to the cradle. Don’t remove the long trans mount bolts as they are TTY bolts.