How do you disarm a fob on a Harley Davidson?
1. Set OFF/RUN switch to OFF , cycle ignition/headlamp switch IGNITION-OFF-IGNITION-OFF-IGNITION and press left turn signal switch twice. 2. Repeat steps listed above. 3. Continue with PIN entry sequence listed You can try disarming with pin following instructions below and see if the fob’s start working afterwards?
How to enter fourth digit of code on Harley Davidson FOB?
9 Press right turn switch 1 time. 10 Enter fourth digit of code (1) by pressing left turn switch 1 time. 11 Press right turn switch 1 time. 12 Enter fifth digit of code (3) by pressing left turn switch 3 times. Security lamp stops blinking and the odo- System is disarmed.
How to program a Harley Davidson touring key fob?
Step 1 – Complete the programming procedure. 1 Step 1 – Complete the programming procedure. Grab your key fob and turn the ignition key on and off for a total of five passes. 2 Step 2 – Visit your local dealer. 3 Step 3 – Start the bike without the key fob.
How long does it take to program a Harley Davidson FOB?
Press and release the left-hand turn switch once. Press and hold the key fob button for 10 to 25 seconds or until the programming process is complete. Turn ignition key off. Figure 1. You can program your key fob in under 10 minutes in most cases. Before getting started, make sure that your key fob has fresh batteries in it.
1. Set OFF/RUN switch to OFF , cycle ignition/headlamp switch IGNITION-OFF-IGNITION-OFF-IGNITION and press left turn signal switch twice. 2. Repeat steps listed above. 3. Continue with PIN entry sequence listed You can try disarming with pin following instructions below and see if the fob’s start working afterwards?
How does a TSSM FOB work on a Harley Davidson?
For a TSSM fob, press the fob button twice while for an HFSM fob, press the right turn switch once. The odometer will show the current PIN. Use the left and right turn switches the way you did to enter the code earlier, and you can have a new PIN for the security system of the motorbike.
Can a Harley Davidson key fob be replaced?
The battery size for the Harley key fob is CR2032, which is replaceable by opening the two pieces that make up the key fob. If the motorcycle fails to start even when you put the ignition on then, perhaps the battery needs to be replaced as the key fob is unable to disarm the anti-theft mechanism so that you can start it.
9 Press right turn switch 1 time. 10 Enter fourth digit of code (1) by pressing left turn switch 1 time. 11 Press right turn switch 1 time. 12 Enter fifth digit of code (3) by pressing left turn switch 3 times. Security lamp stops blinking and the odo- System is disarmed.