How do you clear a catalytic converter monitor?
7 Steps to Follow When Catalyst Monitor Not Ready
- Make Sure the Engine Light is Off.
- Check if your Vehicle has a Coolant Temperature.
- Let the Engine be Idle for 2 Minutes.
- Drive the vehicle at a Steady Speed of 55 MPH.
- Decelerate your Vehicle’s Speed at 20 MPH.
- Again Speed Up.
- Stop the Vehicle.
What should I do if my external monitor is not working?
If Windows Update can find a newer driver, then it’ll download and install the update automatically, hopefully fixing any issues with the external monitor. To reinstall a video card driver that may be corrupted or not working correctly, use these steps: Open Start. Search for Device Manager and click the top result to open the app.
Why is the tire pressure monitoring system light in your civic?
Civic Tire Pressure Warning – TPMS System Failure A driver’s initial reaction when a warning light comes on is to hope it is just a mistake. The TPMS system in your Civic may have a problem, but it is unlikely. Many people who has a problem with the tire pressure system in any vehicle quickly go to every Facebook forum to report it (angrily).
What should I do if my graphics card won’t connect to my monitor?
Check the cable connection between the monitor and the graphics card. Disconnect the cable from both ends, wait a few seconds, and reconnect it again. Use a different cable, as the issue could be the pins in the connector or a bad cable. If the monitor and graphics card include multiple ports, try switching ports.
What should I do if my computer is not detecting my second monitor?
Try a different signal cable to confirm it is not a bad cable. DisplayPort and HDMI come in different versions. As a result, check the manufacturer for requirement details to make sure you have the correct cable. Change ports if the monitor and graphics card include multiple ports.
When do you reset the drive cycle Monitor?
Manufacturers are required to validate monitors during the first 23 minutes (1372 seconds) of the Federal Test Procedure Drive Cycle. Completing the Drive Cycle successfully one (1) time should reset most drive cycle monitors to a “Ready” status.
What do readiness monitors and drive cycles indicate?
Readiness Code Resetting Procedure (Generic Drive Cycle) Readiness Monitors and Drive Cycles “Readiness Monitors” are indicators that demonstrate whether or not emission system components are being monitored (checked) by the OBD-II system.
What to do when your drive cycle is not working?
But if the oxygen sensor and catalyst monitor are ready, then the heater has to be working or the other two monitors would fail and set codes. If the EVAP monitor is not ready, verify that your fuel cap is tight and the level of fuel is between 1/4 and 3/4 full.
What happens at the end of the drive cycle test?
The last step of the general drive cycle test is to complete a final OBD-II scan for trouble codes. This is something that will verify that the drive cycle test has been completed successfully. Sometimes a drive cycle test will discover other hidden emission problems that did not register initially.