How do you clean the throttle body on a Miata?
All you do is buy some throttle body cleaner (make sure it says “safe for teflon coated throttle bodies”, “safe for coated throttle bodies”, or something like that), pull off the intake tube that runs in front of the engine, and then use the cleaner, a rag, and in my case a toothbrush to clean out the black gunk that …
What kind of intake manifold does Mazda use?
With over a year of research and development JMF is proud to introduce the first sheetmetal intake manifold on the market for the Mazda Speed cars. This manifold was designed to not only look awesome but to perform even better.
What do I need to remove intake manifold?
Once you have the piping or TMIC removed, next you want to remove the vacuum thing that is right on top of the manifold: 8mm Bolts (4), a clip, and a hose. Next you will need to remove the power steering pump.
How to remove the air intake in a Mazda 3?
1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Front scuff plate (Passenger-side). b. Front side trim (Passenger-side). c. Resistance Inspection NOTE: Because the IAT sensor is integrated in the MAF sensor, replacing the IAT sensor includes replacement of the MAF/IAT sensor. 1.
How do you replace the intake manifold on a Honda Accord?
Remove the intake manifold. 1. Temporarily tighten the throttle body to the intake manifold. 2. Tighten the installation bolts in the order shown in the figure. 3. Remove the plug from the engine coolant hose and install the water hose to the throttle body quickly. 1. Adjust the convex of the throttle body to the recess of the air hose. 1.
Once you have the piping or TMIC removed, next you want to remove the vacuum thing that is right on top of the manifold: 8mm Bolts (4), a clip, and a hose. Next you will need to remove the power steering pump.
How many bolts are in the intake manifold?
There are 4 bolts (8mm) that is connecting it to the IM. The 2 red circle are the bolts you can see, the 2 blue circles are for the other 2 bolts that you cannot see in the picture but it’s relative to where it should be. Just go ahead and set it aside.
How to remove the PS pump in a Mazda?
For this, you will first need to remove the serpentine belt via the tensioner pulley with a 14mm. Then remove 3 bolts (12mm) holding the PS pump (the top left one, once backed out will not be removed completely). The third one is hidden below but the arrow shows you where it is below.