How do you clean the MAF sensor on a Jaguar?
Then undo the silver jubilee type clip which holds a pipe onto the exit of the housing. Pull the top part of the airbox up, then pull the airbox and the housing away from the pipe carefully. The screws can then be undone with ease with the airbox and housing off the car.
How to clean the Jaguar XK8 throttle body and MAFs?
Articles are provided as a service of Max Performance Cars and are the sole property of the author. MPC is not liable for the content. STEP 5 Have someone hold down the throttle pedal to make it easier to open and clean the throttle body valve. If you have no friends to do this, use something like what I rigged up in the picture.
How to clean part load breather in Jaguar XK8?
MPC is not liable for the content. STEP 13 Clean the Part-Load Breather orifice in the cam cover using a 3/32” (2.5mm) drill bit *firmly* clamped in a Vise-Grip as shown. You can also use a pin vise; the idea is to keep the drill bit from falling into the cam cover.
What kind of gasoline does a Jaguar XJ use?
XJ including LWB Gasoline and Diesel 2006 Model Year, VIN: G49701 onwards Electrical Guide XJ including LWB Gasoline and Diesel 2006 Model Year, VIN: G49701 onwards Published by Technical Communications, Jaguar Cars Limited Publication Part Number JJM 18 38 21 601, April 2006
Then undo the silver jubilee type clip which holds a pipe onto the exit of the housing. Pull the top part of the airbox up, then pull the airbox and the housing away from the pipe carefully. The screws can then be undone with ease with the airbox and housing off the car.
Where is the transmission on a Jaguar XJ6?
Transmissions are a four-speed automatic equipped with a lock-up torque converter. The transmission is mounted to the back of the engine, and power is transmitted to the fully independent rear axle through a two-piece propshaft.
How to tell if your air flow sensor is bad?
Quick test to tell if Mass Air Flow Sensor is bad or dirty which could be causing your car or truck to run bad or keep cutting off. Quick test to tell if Mass Air Flow Sensor is bad or dirty which could be causing your car or truck to run bad or keep cutting off. Skip navigation Sign in Search Loading… Close This video is unavailable.
What kind of engine does a Jaguar XJ6 have?
Models covered Jaguar XJ6 models with 3.2 litre (3239 cc), 3.6 litre (3590 cc) & 4.0 litre (3980 cc) six-cylinder in-line dohc petrol engines and automatic transmission
Is the Jaguar S-type repair information resource available?
No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form: e lectronic, mechanical, including photocopying, recording or other means without prior written permission from the Service Division of Jaguar Cars Limited. DATE OF ISSUE: May 20041
What kind of engine does a Jaguar S-type have?
RW RW RW RW RW RW RW RW PIS45 PIS44 RW RW RW 92 93 F9 10A F10 10A F12 10A F13 20A 8 6 10 7 R19 OY OY OY N N O RW RW RW RW OY BG OY EC49-2 EC49-1 BK S 54 PI41 -12 B G23AL BCRS23 PIS41 PI41 -13 BK PIS42 PIS43 RW BK ECS22 OY F10 11A Electrical Guide S-TYPE Sedan Gasoline and Diesel 2005 Model Year, VIN: N13089 onwards Electrical Guide S-TYPE Sedan
What causes rough idle after replacing mass air flow sensor?
Replaced air filter and maf sensor. Problems with vehicle turning off seemed to go away but now I have a rough Idle. Car will drop below 1000 rpms and then rev back up to over 1500 like it wants to shut off. Idle problems seem to go away when maf sensor is disconnected. Car throwing codes p0171 and p0102.
What happens if I unplug my MAF sensor?
Here are some of the most common symptoms of a faulty mass airflow sensor: The engine is very hard to start or turn over. The engine stalls shortly after starting. The engine hesitates or drags while under load or idle. Hesitation and jerking during acceleration.
What should I use to clean my mass airflow sensor?
After cleaning your mass airflow sensor with either the cleaner, or rubbing alcohol, let it sit, generally for 20 minutes or more. The sensor has to be completely dry before it can be reinstalled in your car, otherwise you may damage it. Replace it and that’s all.
Why is there black stuff on my MAF sensor?
Apparently the Black stuff is pollen and other tiny particulates that make it through the filter and get burned onto the hot bulb at the end, the wires do run through a cleaning cycle that is supposed to burn this stuff off but after a while it needs a clean. Very interesting to hear the great results.