How do you check the transmission fluid on a Kona?
How to Check Transmission Fluid
- To get a proper reading, warm up the engine a bit by letting it run for a few minutes.
- Find the transmission fluid dipstick.
- Remove the dipstick and touch the fluid, moving it around between your thumb and forefinger.
- Use a rag to wipe off the dipstick.
How do you change transmission fluid in a Mercury Mountaineer?
Change the transmission fluid between these intervals for maximum transmission performance and protection. Park the 2002 Mercury Mountaineer on a level location and set the emergency brake. Crawl under the driver side of the Mountaineer and locate the two-part drain plug on the bottom side of the transmission pan.
How to check your automatic transmission fluid level?
Insert long funnel into automatic transmission fluid dipstick hole. Carefully add automatic transmission fluid in small increments and recheck level each time until fluid level reaches “warm” line.
How to add Mercedes Benz approved automatic transmission fluid?
You want to add the Mercedes Benz Approved Automatic Transmission Fluid 236.14 for use with the 5-Speed 722.6 & 7-Speed 722.9 Transmission. Mercedes part# 001 989 68 03 13 Check the level again. You want to double check the fluid level. If you have to added fluid then you must check the level again.
Why do I need to take drip pan out of 2002 Mercury Mountaineer?
Remove the drip pan out from under the 2002 Mercury Mountaineer. The purpose of cranking the engine and shifting through all of the gears is to get the transmission fluid into all areas of the transmission. This will most likely lower the fluid level at the Torx fill hole, thus the need to refill the transmission pan with more fluid.
Change the transmission fluid between these intervals for maximum transmission performance and protection. Park the 2002 Mercury Mountaineer on a level location and set the emergency brake. Crawl under the driver side of the Mountaineer and locate the two-part drain plug on the bottom side of the transmission pan.
How do you check your automatic transmission fluid?
Your dipstick might have two markings for “full”—one warm, one cold. If the automatic transmission fluid level does not come up to the “warm” line, you’ll need to add automatic transmission fluid. Insert long funnel into automatic transmission fluid dipstick hole.
You want to add the Mercedes Benz Approved Automatic Transmission Fluid 236.14 for use with the 5-Speed 722.6 & 7-Speed 722.9 Transmission. Mercedes part# 001 989 68 03 13 Check the level again. You want to double check the fluid level. If you have to added fluid then you must check the level again.
Remove the drip pan out from under the 2002 Mercury Mountaineer. The purpose of cranking the engine and shifting through all of the gears is to get the transmission fluid into all areas of the transmission. This will most likely lower the fluid level at the Torx fill hole, thus the need to refill the transmission pan with more fluid.