How do you check the fuel pressure on a 2006 Nissan Titan?
Turn the truck’s ignition to the “Run” position for 10 seconds, then to the “Off” position for three seconds. Turn the ignition back to the “Run” position and check the connection point between the fuel rail inlet tube and the fuel supply hose for leaks.
How to check the fuel tank in Nissan?
(2) Reference the current Nissan Warranty Flat Rate Manual and use the indicated FRT. Or DESCRIPTION PFP OP CODE SYM DIA FRT Inspect EVAP System (1) FX55AA ZE 22 0.4 Install Fuel Tank FB10AA (2) (1) Reference the electronic parts catalog (FAST or equivalent) and use the part number of the replaced part as the PFP.
What causes inaccurate gas gauge readings on Nissan?
As part of the investigation, it was found that the inaccurate levels were due to problems with the resistors in a circuit of the sender unit. Nissan found one of two resistors could open and cause false gas gauge readings when the tank is below 1/4 of a tank.
Why is my Nissan fuel tank so slow to fill?
Customer routinely experiences difficulty fueling the vehicle at different fuel stations (filling nozzle shuts off every few seconds while filling at multiple stations and using multiple filling pumps). IMPORTANT:
Why does my Nissan think it has more gas?
The problem can leave drivers stranded if they think they have more gas than they really do. It’s an expensive repair that has been recalled before, but not for every affected vehicle. Nissan owners have some trust issues that have them sweating each time they pass a gas station. Should I have filled up again just in case?
Customer routinely experiences difficulty fueling the vehicle at different fuel stations (filling nozzle shuts off every few seconds while filling at multiple stations and using multiple filling pumps). IMPORTANT:
(2) Reference the current Nissan Warranty Flat Rate Manual and use the indicated FRT. Or DESCRIPTION PFP OP CODE SYM DIA FRT Inspect EVAP System (1) FX55AA ZE 22 0.4 Install Fuel Tank FB10AA (2) (1) Reference the electronic parts catalog (FAST or equivalent) and use the part number of the replaced part as the PFP.
What to do if your fuel tank is over ¼ of a tank?
1. If the vehicle fuel tank is above ¼ of a tank, this investigation process CANNOT be performed. Request customer to return with ¼ of a tank or less. 2. Connect the Tech-Mate Dual Purpose Diagnostic Leak Detector (part number 697-95-0130-NIS) to the EVAP service port.