How do you change the transmission fluid on a Mercury Mountaineer?
How to Add Transmission Fluid to a Mountaineer
- Locate the transmission of the Mountaineer.
- Remove the plug by unscrewing it with your hand.
- Place a fluid level tube into the hole and attach a small funnel to the end of the tube.
- Pour the transmission fluid into the funnel until the compartment is full.
How do you change transmission fluid in a Mercury Mountaineer?
Change the transmission fluid between these intervals for maximum transmission performance and protection. Park the 2002 Mercury Mountaineer on a level location and set the emergency brake. Crawl under the driver side of the Mountaineer and locate the two-part drain plug on the bottom side of the transmission pan.
Why do I need to take drip pan out of 2002 Mercury Mountaineer?
Remove the drip pan out from under the 2002 Mercury Mountaineer. The purpose of cranking the engine and shifting through all of the gears is to get the transmission fluid into all areas of the transmission. This will most likely lower the fluid level at the Torx fill hole, thus the need to refill the transmission pan with more fluid.
Where is the fluid catch plug on a Mercury Mountaineer?
Park the 2002 Mercury Mountaineer on a level location and set the emergency brake. Crawl under the driver side of the Mountaineer and locate the two-part drain plug on the bottom side of the transmission pan. The hex head drain plug has a smaller Torx plug in the center of the big plug. Place the fluid catch pan under the area of the drain plug.
Why does Mercury Mountaineer not have a dipstick?
The 2002 Mercury Mountaineer comes with a transmission that does not have a dipstick. The fluid inside of the transmission protects all of the moving gears and seals. The transmission fluid bonds to the gears to prevent heat friction. The transmission fluid also bonds to the seals to keep the seals soft…
How do you add transmission fluid to a Mercury Mountaineer?
It usually involves simply removing a dipstick, inserting a funnel and pouring in the the fluid. Adding transmission fluid to a Mercury Mountaineer is a bit different, however. A Mountaineer does not have a dipstick on the transmission; instead, it has a plug that releases fluid and also allows operators to add fluid.
How much fluid do you put in a mountaineer?
Pour the transmission fluid into the funnel until the compartment is full. A completely dry Mountaineer will generally take around five quarts of fluid. Replace the plug and start the engine. Let the engine idle for about five minutes to allow the fluid to fully lubricate the transmission.
Where is the fluid level plug on a mountaineer?
A Mountaineer does not have a dipstick on the transmission; instead, it has a plug that releases fluid and also allows operators to add fluid. The plug is located on the side of the transmission and can be difficult to reach. Purchasing a fluid level tube and a small funnel from your local auto parts store can make the job much easier.
Park the 2002 Mercury Mountaineer on a level location and set the emergency brake. Crawl under the driver side of the Mountaineer and locate the two-part drain plug on the bottom side of the transmission pan. The hex head drain plug has a smaller Torx plug in the center of the big plug. Place the fluid catch pan under the area of the drain plug.
Change the transmission fluid between these intervals for maximum transmission performance and protection. Park the 2002 Mercury Mountaineer on a level location and set the emergency brake. Crawl under the driver side of the Mountaineer and locate the two-part drain plug on the bottom side of the transmission pan.
Remove the drip pan out from under the 2002 Mercury Mountaineer. The purpose of cranking the engine and shifting through all of the gears is to get the transmission fluid into all areas of the transmission. This will most likely lower the fluid level at the Torx fill hole, thus the need to refill the transmission pan with more fluid.
What kind of Mercon does a Mercury Mountaineer use?
My 2001 Mountaineer’s 4R70W transmission overheats. I replaced the filter and drained the fluid from the torque converter drain plug. I filled the transmission with 12 quarts of Mercon V. The capacity is 13.9 quarts.