How do you change the thermostat on a Honda Prelude?
Use a wrench to open the bleeder bolt located near the thermostat housing. Fill the radiator and tighten the bleeder bolt when you see coolant begin to spill from the bleeder. Start your Honda Prelude and run with the heater blowing on high until the engine warms up. Feel the upper radiator hose to ensure it is getting hot.
What to do when your Honda engine won’t start?
Let the engine run for about 20 minutes with the hood closed. Remove the wire from the throttle linkage and turn the engine off. Let the engine sit for five to ten minutes, then try to restart the engine several times. If the engine doesn’t start, turn the key on.
Why does my Honda Accord shut off when I start the car?
When a timing belt snaps, the engine no longer builds the compression it needs to run. Try to start the car, and listen to the sound it makes. If the tone is significantly different than the standard pulse you’re used to, this may be an indication that the engine is no longer building compression.
Where is the fuel pump relay on a Honda Accord?
Location of fuel pump relay under the driver’s side dash in Honda Accords. Figure 6. 1998 Honda Accord main relay, which feeds current to the fuel pump. If the fuel pump is delivering enough pressure, move on to the next step. A faulty ignition coil, cap, rotor, or wires can cause your engine to stall.
What kind of engine does a Honda Prelude have?
In United States, Honda Prelude was offered in S, Si, SE, and VTEC trim levels. And it was powered by a 2.2 L SOHC engine that could produce 133 hp and 150 pound feet of torque, a 2.2 L VTEC engine that could generate 187 hp and 153 pound feet of torque and a 2.3 L DOHC engine with output of 158 hp and 156 pound feet of torque.
What happens when the Check Engine light comes on on Honda Prelude?
Complete loss of power while acceleration and poor fuel economy are often the symptoms. Once Check Engine Light in Prelude comes on, you had better check if the Prelude oil pump, Prelude crankshaft pulley, valve cover gasket, timing cover, oil filter and Prelude timing belt are in right order. Second, suspension and transmission go wrong.
When did the Honda Prelude 5th generation come out?
These engines were mated to either a 4-speed automatic or a 5-speed manual transmission. On November 7, 1996, the fifth generation Honda Prelude (1996-2001) debuted. Base and Type SH were only available trims. Powertrain was retained from previous generation. As a 2-door sports coupé, Honda Prelude has its own delicacy.
Use a wrench to open the bleeder bolt located near the thermostat housing. Fill the radiator and tighten the bleeder bolt when you see coolant begin to spill from the bleeder. Start your Honda Prelude and run with the heater blowing on high until the engine warms up. Feel the upper radiator hose to ensure it is getting hot.
When did Honda start making the Honda Prelude?
Production of the Prelude concluded in 2001 upon the introduction of the Honda Integra DC5 . The Prelude name was originally trademarked by Toyota, but was amicably given to Honda for use. The Prelude complied with the series of music-themed vehicle names which Honda used at the time, along with the Accord, Quintet, Concerto, Jazz and Ballade .
What kind of moonroof does a Honda Prelude have?
The Prelude also benefited from Honda’s experience with roadsters like the Honda S800 and Coupe 1300. The Prelude was the first Honda model to offer a power moonroof as standard equipment, which eventually became a Prelude trademark.
What kind of engine does a Ford Prelude have?
When the 2-liter 16-valve DOHC engine came out the hood had to be slightly modified since the larger engine could not fit under the original hood. The original 1.8-liter engine was developed specifically for the Prelude to allow a low hoodline, even tilting the engine backward to make it lower yet.