How do you change the rear wiper blade on a 2013 Jeep Wrangler?

How do you change the rear wiper blade on a 2013 Jeep Wrangler?

1. Release the old blade. Lift the wiper arm off the window.
2. Remove the wiper. Once rotated, the wiper will release from the wiper arm with a gentle click.
3. Position the new blade. Place the small bar attachment on the new wiper blade into the hook on the wiper arm.
4. Lock the blade into place.
5. Done!

How do you replace the windshield wiper motor on a jeep?

Reconnect the ground cable to the negative battery terminal. Slide the clamp over the terminal; tighten the retaining bolt using a wrench. Check the wiper blades, and replace them if they are cracked or worn. Disconnect the ground cable from the negative battery terminal before servicing the electrical system.

When do I need to replace my rear wiper motor?

The rear wiper motor is used to turn the arm on your car’s rear window wipers. Since it is typically not used as often as the front windshield wiper, it receives a lot less wear and tear and is less likely to need replacing. However, when it does need replacing, it often gets neglected.

How do you remove an electric wiper motor?

To continue, remove the nut that holds the assembly to the electric motor. Once you remove this nut, you should be able to simply pull the wiper arm aware from the motor. Put it aside in a safe location as this piece is prone to damage. To remove the wiper motor, first unplug it.

What’s the best way to replace a windshield washer?

Step 1: Install a nine-volt battery saver into your cigarette lighter. This will keep your computer live and keep your settings current in the vehicle. If you do not have a nine-volt battery saver, you can complete the replacement without it; this just makes it easier. Step 2: Disconnect the battery.

How do you change the wiper motor on a Jeep Wrangler?

You have to unbolt the struts from the windshield frame and lay the frame out on the hood to switch the wiper motor. Getting the plug undone is the tricky part. The part that is on the motor side will fit through the opening in the top of the dash, but the part on the Jeep harness side doesn’t.

How can I get my windshield wipers to work?

My squirters work just fine, its just the windshield wipers. The wiper motor is fairly cheap, I have seen them on Ebay for around $35. You have to unbolt the struts from the windshield frame and lay the frame out on the hood to switch the wiper motor.

Where do you unplug the Jeep harness plug?

Getting the plug undone is the tricky part. The part that is on the motor side will fit through the opening in the top of the dash, but the part on the Jeep harness side doesn’t. So you almost have to crawl up under the dash to unplug the wires.