How do you change the oil on a 2006 Mercury Mariner?
Oil & Filter Change Mercury Mariner (2005-2011)
- Find Oil Drain – Locate the oil drain plug underneath the vehicle.
- Find Oil Filter – Locate the oil filter.
- Remove Oil Cap – Take off the oil fill cap.
- Replace Cap – Put the oil fill cap back on the engine.
- Car Displayed: 2005 Ford Escape Limited 3.0L V6.
What oil does a Mercury Mariner take?
Engine Oil
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.8 quarts (with filter)After refill check oil level. |
| Torque: | 21 ft/lbs (Oil Drain Plug) |
Where to find spark plugs for Mercury Mariner outboard?
Find spark plugs for your 2-stroke Mercury Mariner outboard using the application chart from the Mercury Quicksilver catalog. Need other parts? If you need parts not listed in the application guide, please see: Standard Plug Manf. Part Supressor Plug Manf. Part
What kind of oil does a 2005 Mariner use?
Oil and Transmission Both engines use synthetic multi-vehicle automatic transmission fluid (ATF) and SAE 5w20 engine oil. Use the same fluids as in the transmission in the transfer case. The 2005 Mariner uses brake, clutch and power steering hydraulic systems.
What kind of engine does a Mercury Mariner have?
The 2005 Mercury Mariner comes stock in two engine sizes: a 2.3-liter four-cylinder engine and a 3.0-liter six-cylinder engine. The factory-recommended fluid types and levels encompass oil and transmission, transfer case and rear differential, along with the various hydraulic systems.
How do you test the fluid level on a 2005 Mariner?
Use an allen wrench to test the level of fluid. Insert the short end of the allen wrench into the opening and remove. The tip should show just a little bit of fluid when case is full. The 2005 Mariner uses brake, clutch and power steering hydraulic systems.