How do you change the headlight on a Chevy Equinox?
Pull the headlight assembly from the lower outside corner. The retaining clip holding the assembly will disengage with the right amount of pressure. Tip the headlight assembly downward to reveal the wire harnesses plugged into the bulbs. Be sure you’re placing the right bulb in the right locations.
How do you remove a headlight from a car?
Pull the assembly out from the outside corner and remove the retaining clip. Tip the headlight down and you will see where the bulbs clip in to the housing. Low beams are on the outside of the assembly — high beams are on the inside. Turn the retaining ring counterclockwise and pull the bulb out.
How do you replace a headlight on a radiator?
Place the headlight into the headlight assembly, and turn the retaining ring clockwise until it locks into place. Replace the headlight assembly, making sure to align and engage the retaining clip into place. Replace the three headlight bolts, and tighten them. Manipulate the fascia assembly and radiator trim retainer into the headlight assembly.
Where are the retainers on a Chevrolet Equinox?
Open the hood to the Chevrolet Equinox. Locate the 4 push in retainers that are holding the fascia assembly along the top front rail of the engine compartment. Press in the center of the retainers, and pry them up and out with the flathead screwdriver.
Pull the headlight assembly from the lower outside corner. The retaining clip holding the assembly will disengage with the right amount of pressure. Tip the headlight assembly downward to reveal the wire harnesses plugged into the bulbs. Be sure you’re placing the right bulb in the right locations.
Place the headlight into the headlight assembly, and turn the retaining ring clockwise until it locks into place. Replace the headlight assembly, making sure to align and engage the retaining clip into place. Replace the three headlight bolts, and tighten them. Manipulate the fascia assembly and radiator trim retainer into the headlight assembly.
Open the hood to the Chevrolet Equinox. Locate the 4 push in retainers that are holding the fascia assembly along the top front rail of the engine compartment. Press in the center of the retainers, and pry them up and out with the flathead screwdriver.