How do you change the gas tank on a GMC pickup?
Add fuel to the tank and prime the fuel system by turning the key on and letting the fuel pump run briefly and then turning it off. Repeat this several times to be sure the pump has primed and filled the fuel lines with fuel. Test-run the truck and check for any leaks around your connections.
How to change a broken fuel pump without dropping the gas tank?
TheCousinDan shows you how to change a broken fuel pump without dropping the gas tank. This time it’s done by actually cutting a hole in your car (don’t worry, it’s not as bad as it sounds). Music: NCS Def Kev
What’s the best way to drop a gas tank?
Step 1: Park your vehicle on a flat, hard and level surface. Step 2: Remove any fuel from the vehicle. Using the fluid pump and the container, pump out as much of the fuel from the tank as you can by going through the fuel filler port. The more fuel you remove, the lighter the tank is – making it easier to remove.
Why is my gas tank leaking on my GMC Truck?
There are two steel straps that run under the tank and up to the frame rails of the truck for support. Dirt, water, and other debris can become trapped under these straps and cause the tank to leak. If this happens to your tank, you will need to replace it with a new tank.
Is it safe to remove a fuel tank?
A simple, step by step process for removing a fuel tank. A safer and effective fuel pump repair job begins here. Cleaning the fuel tank is an essential part of a complete fuel repair. Before installing a new fuel pump, it’s critical to properly clean the gas tank. Debris in your gas tank will damage your new fuel pump.
How to remove a fuel pump from a truck?
Basic instructions on how to tip your bed and remove your fuel pump and sender assembly, replacement of the fuel pump from the sender unit and putting it back into the tank with gasket o-ring and lock ring. I also show video of the bolt hole locations on my short bed frame. Loading…
Add fuel to the tank and prime the fuel system by turning the key on and letting the fuel pump run briefly and then turning it off. Repeat this several times to be sure the pump has primed and filled the fuel lines with fuel. Test-run the truck and check for any leaks around your connections.
How to drop a Silverado / Sierra gas tank?
How to drop a Silverado / Sierra gas tank. – YouTube If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: i7LhU7PJbdsUiSKQ) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
There are two steel straps that run under the tank and up to the frame rails of the truck for support. Dirt, water, and other debris can become trapped under these straps and cause the tank to leak. If this happens to your tank, you will need to replace it with a new tank.
What kind of trailer does GMC Sierra 3500 have?
We appreciate your interest in GMC and we’ll send the information you requested soon. Requires Sierra 3500 HD Regular Cab Long Bed 2WD DRW with available Duramax 6.6L Turbo-Diesel V8, Max Trailering Package and gooseneck hitch. Before you buy a vehicle or use it for trailering, carefully review the Trailering section of the Owner’s Manual.
How big does a GMC Sierra crew cab need to be?
The 18,500 lbs. rating requires properly equipped 2500 Crew Cab model with available 6.6L Duramax Turbo Diesel and fifth wheel or gooseneck hitch. Before you buy a vehicle or use it for trailering, carefully review the trailering section of the Owner’s Manual.
What kind of engine does a GMC 3500 have?
Requires properly equipped 3500 Regular Cab DRW Long Box 2WD model with available 6.6L Duramax Turbo Diesel engine and gooseneck hitch. Before you buy a vehicle or use it for trailering, carefully review the trailering section of the Owner’s Manual. The weight of passengers, cargo and options or accessories may reduce the amount you can tow.
What kind of engine does GMC Sierra have?
The weight of passengers, cargo and options or accessories may reduce the amount you can tow. Requires properly equipped 3500 Crew Cab SRW Standard Box 4WD model with available 6.6L Duramax Turbo Diesel and fifth wheel or gooseneck hitch.
Is the GMC G series gas tank out of stock?
If you do not see your Gas Tank give us a call at 386-788-8837 for a quote. This item is currently Out of Stock 4-6 Weeks! This item is currently Out of Stock 4-6 Weeks! IGM26C Gas Tank for 1987-1996 Chevrolet, GMC G-Series Van, 33 Gallon.
What kind of gas tank does a Chevy Silverado have?
Fuel Filler Neck Components 2007-13 Chevy Silverado 2007-13 Tahoe, Suburban Gas Tank Filler Components Standard & Extended Cab 1994-03 Chevy S10 1994-03 Gas Tank Components Crew Cab 2001-04 Chevy S10 2001-04
How do you replace a fuel tank vent?
After the epoxy has set cut the nipple of off the old vent valve. Then insert the cut side of the nipple into the hose leaving enough space for the locking clip on the fitting. This is the finished product, it is stronger than the oem fitting and sealed back up nicely.
When did GMCs envoy start using Active Fuel Management?
I’ve read at many websites that the GMCs envoys, Chevys and saabs did start to come with AFM in 2005 with the LH6 motor,It says here it started in 2006 on the saabs, then the pick-ups got AFM in 2007.
How to disable Active Fuel Management on GM LS?
There are two ways to disable or delete Active Fuel Management on your GM or Chevy Gen IV LS or LS-based Vortec engine—one is to install an AFM Disabler, and the second is to install an AFM Delete Kit. Here’s what you need to know: 1.
How does the fuel tank EVAP system work?
Fuel tank pressure monitor (1998 and1999 model) The EVAP control system is a system which utilizes the intake manifold vacuum to draw the evaporative emissions into the intake manifold and mix then in with the intake air. The ECM controls a duty−cycle type VSV (vacuum switching valve) to purge the evaporative emissions from the charcoal canister.
Can You Drop a fuel tank without ground wire?
Stuff a good size rag in there to keep crap from falling in there. Then remove the ground wire from the fuel pump that is attached to frame rail. You can drop the tank without doing this but it is a lot easier and you won’t have to worry about braking it.
How to drop a Silverado / Sierra gas tank. – YouTube If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: i7LhU7PJbdsUiSKQ) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
How do you replace the fuel pump on a flatbed truck?
For most vehicles, the only way to replace the fuel pump is by dropping the tank, which could take a long time. But on most flatbed pickup trucks, there’s a simpler way to access the troublesome fuel pump. Simply unbolt the bed and lift that sucker up!
What’s the best way to remove gas from a gas tank?
Tip: Use clear tubing to make it easier to monitor the flow of gas. Step 1: Connect the longer tube. Take two lengths of tubing – one longer than the other. Take the longer tube and connect one end to the gas tank and the other to the fuel container. Step 2: Connect the shorter tube.
Can a rusted bolt be removed from a car?
Rusted bolts and studs that break when being removed are the worst nightmare of any mechanic, and anyone else trying to fix a machine. Luckily, if you are a handyman who likes to take care of your vehicle in your own garage, there are now a number of options that weren’t available 20 or 30 years ago on how to remove a broken bolt.