How do you change a clutch cable on a motorbike?
Insert the cable’s barrel end into the clutch lever’s recess. Pull the cable through the channel cut into the clutch lever. Screw the cable onto the clutch lever perch and adjust the cable tension using the cable adjuster. Turn the adjuster clockwise to loosen the cable, counterclockwise to to tighten the cable.
How do you disconnect the clutch from the clutch?
You may be able to disconnect this by pushing the clutch operating lever away from the nipple with your fingers, then pulling the nipple out of the lever with pliers. But if the cable is too tight, you must slacken the cable tension. Look back along the cable and find the cable adjuster.
Where do you change the clutch cable in a car?
It may be at the point where the outer cable passes through the gearbox bell housing, or where it passes through the bulkhead (see Mechanics 35 and 36). Once the cable is loosened enough, pull the cable nipple out of the clutch lever. Remove the rubber boot (if fitted) and check it for holes. Replace it if necessary.
How do you replace the cable on a clutch fork?
Step 7: Slide the cable end through. Make sure it goes through the slot on the clutch fork. Step 8: With the cable removed, inspect the clutch fork condition. Lube any grease zerks that are located on the clutch fork and bell housing. Step 9: Put the cable end in the slot of the clutch fork. Mount the cable to the bracket near the clutch fork.
What is the part number on the clutch cable?
Resetting the cable with the part number GCC102 is relatively easy. Firstly, push the inner cable from the clutch side to the stop into the outer cable. Then pull the inner cable out again completely which puts the automatic adjuster into its starting position.
How do you adjust clutch?
Step 1 Locate the end of the clutch cable on the transmission. Loosen the cable nut. Pull the cable end through the adjuster hole with pliers while keeping the wrench on the adjuster nut on the linkage. Test your work by engaging and disengaging the clutch with the engine on.
Can the clutch cable be adjusted?
Adjusting the clutch is most typical for cable type clutches, and the cable will be adjusted by changing the length of the cable on the clutch fork . This can be done with shims or an adjusting nut. Hydraulic clutches have some adjustment at the clutch pedal, and many can be adjusted by turning an adjusting screw and pinch-nut on the slave cylinder or moving the slave cylinder in eccentric holes. However, in some cases, changing the pushrod for the slave cylinder is necessary for adjustment
Can I adjust the clutch?
Part 1 of 3: Measure Clutch Pedal Freeplay Measure the clutch position. Set a block of wood down next to the clutch pedal. Press the clutch and measure its position. Press the clutch pedal several times. Determine clutch pedal freeplay. Now that you have a measurement of the clutch pedal height when it is disengaged and engaged, you can use the measurements to determine
How do you adjust the clutch on a Harley Davidson?
How to adjust a motorcycle clutch on a Harley Big Twin Step 1: Remove the clutch cable cover Step 2: Adjust the clutch cable (Part 1) Step 3: Remove the clutch cover (aka the derby cover) Step 4: Loosen the jam nut on the clutch adjuster Step 5: Adjust the clutch Step 6: Put the derby cover back on Step 7: Adjust the clutch cable (Part 2)