How do you adjust the rear drum brake on a jeep?
Pull the adjuster lever downward and then unhook it from the adjuster lever pin attached to your Jeep’s brake shoe. 8. Unhook the brake shoe adjuster cable from the adjuster lever and set it aside. 9. Using a pair of vice grips, clamp onto the brake shoe return spring attached to the forward facing brake shoe and then pull it off the anchor pin.
How do you remove a brake shoe from a Jeep Cherokee?
Reach behind your Jeep’s drum brake backing plate and press on the hold down spring pin. Then, using a brake spring compressor tool, push on the brake shoe hold down spring retainer and give it a twist to release it from the pin. Remove the shoe and repeat the process on the opposite shoe.
Where can I buy brake shoes for my Jeep TJ?
You can find and purchase drum brake shoes, replacement hardware/spring kit, and all the other tools you need to service your Jeep TJ’s rear brakes at Autozone, Kragen, Napa and Pepboys. If needed, most of these stores should be able to resurface your old brake drums if needed for a small fee.
What do I need to remove rear brake drum?
If this is the first time removing your Jeep’s rear brake drums for service or replacement, you will need to first remove a couple of retaining clips securing it in place. These clips are attached to the wheel studs, look like brass washers and will require a small flathead screwdriver and/or needle nose pliers to remove.
Is the rear drum brake on a Jeep Cherokee?
(Playback ID: eJbO18XE_JLnUxwo) An error occurred while retrieving sharing information. Please try again later.
Can you adjust the brakes on a jeep TJ?
The rear drum brakes on a Jeep TJ have been designed with a self-adjusting mechanism. Typically, no adjustments are needed to the brakes unless you have just replaced the drums, shoes or have removed the shoes for other reasons. Below are instructions on how to adjust your rear drum brakes using a brake spoon adjuster tool.
Reach behind your Jeep’s drum brake backing plate and press on the hold down spring pin. Then, using a brake spring compressor tool, push on the brake shoe hold down spring retainer and give it a twist to release it from the pin. Remove the shoe and repeat the process on the opposite shoe.
If this is the first time removing your Jeep’s rear brake drums for service or replacement, you will need to first remove a couple of retaining clips securing it in place. These clips are attached to the wheel studs, look like brass washers and will require a small flathead screwdriver and/or needle nose pliers to remove.
Pull the adjuster lever downward and then unhook it from the adjuster lever pin attached to your Jeep’s brake shoe. 8. Unhook the brake shoe adjuster cable from the adjuster lever and set it aside. 9. Using a pair of vice grips, clamp onto the brake shoe return spring attached to the forward facing brake shoe and then pull it off the anchor pin.
How do you remove a parking brake strut?
Your Jeep’s drum brake adjuster screw is loosely held in by compression. Carefully spreading your Jeep’s brake shoes apart will allow you to remove it with ease. 16. Again, carefully spread apart your Jeep’s brake shoes enough to remove the parking brake strut and springs.