How do you adjust the headlights on a Hyundai Elantra?
Shine the headlights onto the flat surface. Open the hood and locate the two access holes on the top of the Elantra’s headlight housing assembly. Remove the two rubber stoppers, one covering each hole, by pulling them out with your fingers. This will expose the adjustment screws.
How do you replace a headlight switch on a Hyundai?
Once you remove the steering wheel, you will be able to access the clock spring. Before you can remove the clock spring, you will need to remove the plastic trim held in place with three screws. This opens in a new window. Remove two Phillips screws that hold the headlight switch in place.
How to replace combination switch on a Hyundai Elantra?
Replacing Hyundai Elantra Headlight / Turn Signal Switch yourself will cost you less than $200 in parts if purchased online. You will need the right tools and two hours to change the headlight/turn signal/ wiper switch. Owners of the following Hyundai vehicles will find these instructions helpful.
How do you change a headlight assembly on a car?
Position the assembly so that the bracket tabs are aligned with their slots and slide the headlamp inward to engage the tabs. Replace the two bolts at the top of the assembly. If you’re replacing both assemblies, repeat these steps on the other side.
How to replace a head light bulb on a Hyundai Elantra?
Complete instructions for replacing a head light bulb on a 2002 Hyundai Elantra GLS 2.0L 4 Cyl. About Us Maintenance Parts & Tools Contact English SpanishFrench Search Home Hyundai Elantra 2005 Lights / Headlight (replace bulb) Headlight Change 2001-2006 Hyundai Elantra 1. Getting Started – Prepare for the repair Learn More > 2.
How do you replace a headlight in a car?
Remove the 10mm bolt at the top of the separator and remove it from the car. Remove the two bolts at the top of the headlight assembly, and 1 bolt at the bottom. Pull the headlight free of its frame. Find the wiring harness connector, release the clip and pull the headlight free. Remove the headlight bulb cover from the bulb you need to replace.
Is the HighBeam the same bulb as the headlight?
In some Hyundais, the highbeam is the same bulb as the headlight and it is possible for the highbeam to work, but the headlight be burnt out even if they are the same bulb (and vise versa). Some Hyundais have high intensity discharge headlights, sometimes referred to as xenon lights.
How do you adjust the position of the headlight?
Turn on the headlight switch. (Low Beam Position) 1. Adjust headlights so that main axis of light is parallel to center line of the body and is aligned with point “P” shown in the illustration. 2. Dotted lines in the illustration show the center of headlights. Horizontal center line of headlights from ground: 35.6 in. (904 mm).
When to adjust horizontal aiming on a Hyundai?
Horizontal aiming must be adjusted by an authorized Hyundai dealer to avoid incorrect alignment that will reduce the effectiveness of your headlights. If the vehicle has had front body repair and the headlight assembly has been replaced, the headlight aiming should be checked using an aiming chart as shown in the illustration.
How to adjust headlight beam on Hyundai Tucson?
Draw a vertical line (through the center of each headlight beam pattern) and a horizontal line (through the center of each headlight beam pattern) on the aiming screen. And then, draw a parallel line at 0.8 in. (21 mm) under the horizontal line.
Shine the headlights onto the flat surface. Open the hood and locate the two access holes on the top of the Elantra’s headlight housing assembly. Remove the two rubber stoppers, one covering each hole, by pulling them out with your fingers. This will expose the adjustment screws.
Are there any problems with the Hyundai Elantra?
Hyundai Elantra owners have reported 69 problems related to headlights (under the exterior lighting category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Hyundai Elantra based on all problems reported for the Elantra.
Horizontal aiming must be adjusted by an authorized Hyundai dealer to avoid incorrect alignment that will reduce the effectiveness of your headlights. If the vehicle has had front body repair and the headlight assembly has been replaced, the headlight aiming should be checked using an aiming chart as shown in the illustration.
Turn on the headlight switch. (Low Beam Position) 1. Adjust headlights so that main axis of light is parallel to center line of the body and is aligned with point “P” shown in the illustration. 2. Dotted lines in the illustration show the center of headlights. Horizontal center line of headlights from ground: 35.6 in. (904 mm).