How do you adjust the emergency brake on a 2013 Honda Civic?
- Pull the parking brake lever 1 click.
- Tighten the parking brake adjusting nut until the parking brakes drag slightly when the rear wheels are turned.
- Release the parking brake lever fully.
- Check that the parking brakes do not drag when the rear wheels are turned.
- Readjust if necessary.
How do you adjust the parking brake on a 2009 Honda Civic?
Adjustment – Rear Drum Brake Type
- Remove the front console panel.
- Release the parking brake lever fully.
- Loosen the parking brake adjusting nut (A).
- Press the brake pedal several times to set the self-adjusting brake before adjusting the parking brake.
- Pull the parking brake lever 1 click.
How to make parking brake adjustments in a Honda Accord?
Raise the rear of your car to assist in the adjustment. Remove the center console cover around the parking brake lever located inside the car between the driver’s seat and the front passenger seat.
How do you turn off the parking brake on a Honda?
To do this: Bring the vehicle to a stop with the brake pedal and shift to NEUTRAL. Turn off the ignition, and push the parking-brake switch down within 2 seconds. The automatic activation will be suspended, and will be restored when the vehicle is restarted.
What’s the best way to adjust a parking brake?
Step 2: Turn the self-adjuster counterclockwise. Most of the time – but not always – you will want to turn the nut counterclockwise to provide slack in the cable system. You do not want the cables to become slack and loose. You only need enough slack in the cable system so that they are not pulling on the rear shoe parking brake adjuster.
Where is the parking brake cable adjuster located?
Note: Refer to your owner’s manual if you are not certain about jack stand placement. Step 1: Locate the brake cable adjuster. The brake cable adjuster is usually located in one of two different places: either under the car about midway between the front and the rear, or attached to the parking brake lever.