How do you adjust the accelerator cable on a go kart?
Throttle cables have adjustment at both ends, make all adjustments at engine side. Loosen the jam nuts and move the housing closer to the throttle arm to decrease the amount of throttle pull, move the cable away from the throttle arm to increase the amount of pull. Tighten jam nuts when completed.
How do you adjust the accelerator cable on a go-kart?
Can a starter motor be used for a go-kart?
starter motor would probably work, but assuming you’re using the starter solenoid to run the starter, you’re not going to have any speed control, just off/on.
Is throttle cable and accelerator cable the same?
An accelerator cable, sometimes called throttle cable, is a metal braided cable that serves as a mechanical link between the gas pedal and the engine’s throttle plate. When the gas pedal is pressed, the cable is pulled and opens the throttle.
How much does a throttle cable cost?
How much does a throttle cable replacement cost? A throttle cable replacement usually costs around $50 to $100. It is usually sold individually but some are sold as part of a kit. Again, remember to check for compatibility before buying a throttle cable replacement.
What kind of cables do you need for a go kart?
We carry a full line of go kart cables such as reverse, shifter, throttle, choke and brake cables for Hammerhead, Yerf Dog, TrailMaster, Carter Brothers and Manco go karts. 60″ long universal throttle cable, barrell on one end ball on the other.
How is the throttle cable installed on a go kart?
After you have the throttle pedal, stops, and cable tab installed, it is time to install the go kart throttle cable. Referencing the picture above, you simply unscrew one of the bolts on the cable housing, and slide the end through the tab’s 5/16″ hole.
What is the Universal wire stop on go kart?
This universal wire stop is used on throttle cables and brake cables. Fits Throttle Cable 04-261, 04-262, 04-263, 04-269 and Brake Cable 04-264. This universal wire stop is used on throttle cables and brake cables. Fits Throttle Cable 04-261, 04-262, 04-263, 04-269 and Brake Cable 04-264.
Where is the gas pedal on a go kart?
The following hardware was used for the complete throttle assembly from the pedal to the engine: The go kart throttle pedal (also known as a gas pedal) is the one on the right of the picture with its associated return spring and hardware used to mount it to the go kart frame.