How do you adjust primary chain tension on a Harley Davidson?
To adjust the primary chain tension on a Harley-Davidson Big Twin, loosen the nut you see facing you through the inspection hole, and raise the plastic shoe until the chain tension is correct. To adjust the primary chain tension on a Sportster, loosen the lock nut on the
How do you adjust the primary chain on a Sportster?
primary chain tension on a Sportster, loosen the lock nut on the adjuster on the bottom of the primary case, then turn the primary adjustment bolt clockwise with an Allen wrench to increase the tension and remove slack from the chain. Retighten the lock nut when you
How often should you change the chain on a Harley Davidson?
These chains don’t stretch much if the engine is kept stock or near stock, so in most cases you’ll just check it every 5,000 miles and won’t need to adjust it, but it’s good to know that when it is time to adjust the chain it’s a simple process you can do yourself.
How big should the chain be on a Harley Davidson Sportster?
For a big twin it should be 5/8 to 7/8 inch (16 – 22 mm) when the engine is cold, and for a Sportster it should be 3/8 to 1/2 inch (9.5 – 12.7 mm) when the engine is cold. This measurement is for the TIGHTEST section of the chain, and chains do sometimes wear unevenly and get stretched in places.
How do you adjust the chain on a Harley Davidson?
With the socket wrench, loosen the chain-adjustment bolt. With your chain adjuster sits. chain. To adjust the chain, move the bolt up higher on the bracket. This moves the adjuster to make the chain tighter. Conversely, move the bolt lower on the bracket if the chain is too tight.
What happens when a Harley Davidson chain is too tight?
If the chain is too tight, you’ll feel it (might feel jerky, especially when it’s hot), but a loose chain usually you’ll hear, particularly when cold, a slap that kind of just goes “tick, tick, tick, tick”.
How do you adjust the chain on a Jeep Cherokee?
With your chain adjuster sits. chain. To adjust the chain, move the bolt up higher on the bracket. This moves the adjuster to make the chain tighter. Conversely, move the bolt lower on the bracket if the chain is too tight. Move the bolt one the desired tightness (see owner’s manual). Install the new oil plug on the clutch reservoir.
How does the belt drive on a Harley Davidson work?
The final belt drive is tightened my moving the wheel back, which involves loosening the axle, tigthening adjuster bolts evenly on both sides, etc. If they didn’t touch the adjuster bolts, then it should be the same tightness it was before.