How do I turn on my AWD Rogue?
The AWD LOCK switch located on the lower side of the instrument panel. This switch is used to select the AUTO or LOCK mode depending on the driving conditions. AUTO. will illuminate.
How do you set the CLOCK on a 2008 Nissan Rogue?
Touch SETTINGS. Touch CLOCK. Touch ON-SCREEN CLOCK to turn the time display ON/OFF. Touch CLOCK MODE to select Auto, Time Zone or Manual.
How to remove AWD from a Nissan Rogue?
Remove the wheel hub lock nut. Remove the hub bolts and the wheel hub and bearing. Position the parking brake and back plate aside with wire. Remove the coil spring and spring seats. Refer to RSU-10, “Removal and Installation – AWD”. Remove the axle housing.
How to remove rear speed sensor from Nissan Rogue?
Failure to remove the rear speed sensor from the axle housing may result in damage to the rear wheel sensor. Pull out the rear wheel sensor, being careful to turn it as little as possible. do not pull on wheel sensor harness. Remove torque member bolts using power tool, leaving the brake hose attached. Position brake caliper aside with wire.
How to remove the engine cap on a Nissan Rogue?
Wrap a thick cloth around the cap. Slowly turn it a quarter turn to allow built-up pressure to escape. Carefully remove the cap by turning it all the way. Perform when the engine is cold.
How to install a CVT on a Nissan Rogue?
When installing the CVT to the engine, align the matching mark on the drive plate with the matching mark on the torque converter. When installing the drive plate to torque converter nuts, tighten them temporarily. then tighten the nuts to the specified torque.
What is the Nissan Rogue removal and installation manual?
Refer to EM-81, “Removal and Installation (FWD)” (FWD) or EM-85, “Removal and Installation (AWD)” (AWD). NOTE: Using paint, put matching marks on the drive plate and torque converter when removing the torque converter to drive plate nuts.
Wrap a thick cloth around the cap. Slowly turn it a quarter turn to allow built-up pressure to escape. Carefully remove the cap by turning it all the way. Perform when the engine is cold.
When installing the CVT to the engine, align the matching mark on the drive plate with the matching mark on the torque converter. When installing the drive plate to torque converter nuts, tighten them temporarily. then tighten the nuts to the specified torque.
What happens when you replace transaxle on Nissan Rogue?
When replacing an engine or transaxle you must make sure any dowels are installed correctly during re-assembly Improper alignment caused by missing dowels may cause vibration, oil leaks or breakage of drive train components. Do not reuse O-rings or copper sealing washers.