How do I switch my house alarm off?
You can turn off or power down your home alarm system by disconnecting its backup battery and then unplugging the transformer for the device from the wall outlet. You can confirm that the panel has been powered down by checking its touchscreen or keypad and making sure that it is blank.
Where do you place Pirs?
The best place to fit a PIR is in the corner of a room. This ensures maximum coverage of the space as the device maps out its grid. Choke-points are the areas in your home with the most traffic. These could be entry doors or hallways.
Where is my alarm battery?
The security system battery is located in the control panel, usually placed in the basement or utility closet. In the event of an outage, your battery should last (provide power to your system) for about 48 hours.
How high up should you put a motion sensor?
Overall, a motion detector should be mounted on the wall, between 6 and 8 feet high. Some people also put their motion detectors on or near the ceiling. That can work with a standard ceiling height — which is around eight feet — but may not be the best choice for any homeowner who has 10 or 12-foot-tall ceilings.
How far can a motion sensor detect?
80 feet
Typical motion sensors have a range of up to 80 feet, meaning a single motion sensor probably won’t cover a long hallway or an open workspace. You can hire a security company like Bay Alarm to install your security system.
Why is my home alarm system not working?
Your first instinct is probably to use your code to turn off the system, and this is the correct thing to do. Unfortunately, some problems can prevent the keypads from communicating with the main panel. The keypads can then become unresponsive to the usual arm/disarm codes and other commands.
What to do if your alarm panel has a misaligned switch?
If you do find a misaligned or widely spaced magnet and switch, remove the magnet and re-mount it in the proper position. (For help doing this, check out “Installing Recessed Switches” and “Installing Surface-Mount Switches”) Damage often occurs when a door or window is slammed hard, causing the magnet to hit the contact or wiring.
Is there a way to turn off the car alarm?
If the doors unlock and the alarm continues to go off, there may be a specific way to turn off the alarm for the aftermarket model you may have. If it has a “switch” turn it to the “on” position. Hold the black button down and press the gas pedal at the same time while the key turned to the on position in…
What should I do if my home alarm keeps going off?
If the alarm keeps going off, it may be necessary to shut down the system until service can be arranged. If you have home alarm system monitoring, and/or use a home alarm company for service, call them before doing anything else. They know your system, and are in the best position to help you!
What should I do if my alarm panel is not working?
Along with a meter, we need to thermally “shock” the switches on the problem zone with a rapid temperature change. This will (hopefully) cause the bad switch to change resistance and show itself. In moderate or hot weather, the easiest way to do this is with canned chiller spray.
What causes intermittent opening of an alarm switch?
Intermittent zones are usually due to a failing alarm switch, also known as an alarm contact. Intermittent opens can also be caused by misaligned magnets and contacts. This page explains in detail how to find and fix these problems.
How do you disable an all in one alarm system?
You can disconnect its wiring when you open the main panel, which is the next step anyway. For all-in-one units, disable the alarm by first separating the front face of the unit from its base. These usually snap together using hooks or tabs, and come apart easily by inserting a small screwdriver to release them.
What causes an alarm to go off when the door is closed?
A thermal swinger does this in response to changes in temperature. A switch that swings from low to high resistance will be seen by the security panel as an open zone, even though the door or window may actually be closed. If the panel is armed when this happens, a false alarm is the result.