How do I setup my Cobra CB?
Turning the “Squelch” control counterclockwise allows all of the signals in. Turn the “Squelch” control clockwise until you hear the noise stop. This sets your Cobra CB to the Desired Squelch Setting (DSS). Adjust the Dynamike clockwise to reach the maximum voice volume.
How many watts does a cobra 29 put out?
| SPECIFICATIONS | |
|---|---|
| Unit Dimensions: | 7-1/4 x 2-1/4 x 8-5/8 |
| Frequency Control: | Phase Lock Loop Synthesizer |
| RF Output Power: | 4 Watts (Maximum FCC allowed) |
| CB Channels: | 40 Channels (26.965 to 27.405 MHz) |
Why does my Cobra 29 LX say antenna warning?
Check your antenna ground make sure that the antenna is grounded good,if you are using a mag mount some time these antennas don’t make good ground this will cause the light to come on at times,and if not make sure that your antenna is grounded very well,1.3 swr is not that bad but i would try to get it a little lower …
Why is my ant light on Cobra 29?
A common reason for the ant light to light up is that the antenna is not grounded properly. Check out this page from Firestik for more information on swr and cb’s. If your ant light is on when you transmit, stop using the radio and fix the swr. You will ruin the radio.
How do I connect my Cobra iRadar to my Iphone?
In order to pair iRadar to your smartphone, go to the Bluetooth Settings Menu on your phone/tablet. For most devices this is found by pressing; Settings ▶ Bluetooth. Press Scan for Devices and/or wait for the Device list to populate and then select iRadar. Pairing can take up to 30 seconds.
Why is my CB say antenna warning?
The red light is a warning of antenna mismatch; when you hold the antenna, you are changing the match between the CB’s output amplifier and the antenna. Try it with a different antenna or pick up a ‘test light’ (or test load) for CBs from an electronics dealer, I’ve also seen them with CB accessories at truck stops.
How do I know if my CB antenna is bad?
Luckily, testing an antenna is a fairly easy process….Testing for a Defective CB Antenna
- Using your multimeter, touch one of the probes to the metallic end of the antenna.
- Touch the other probe to the metallic threads at the end of the antenna.
- As you maintain contact with both probes, measure the circuit’s resistance.
Why is my CB not transmitting?
Yep it’s sounding like it has a bad power or ground connection. A weak power or ground connection can provide enough power for the CB to turn on & receive but not be able to pass the additional power (current) required by the CB when it is trying to transmit.