How do I reset my Viper alarm without a remote?
To disarm your alarm without a remote you will need to enter your vehicle using your traditional key. The alarm will sound at this time. Once inside the vehicle locate your valet switch.
How do I get my Viper alarm out of valet mode?
This method has you open the driver door, then press the lock button, immediately followed by the unlock button, immediately followed by the lock button again. The LED will illuminate solid to indicate the vehicle is in valet mode. To exit this mode, simply repeat the process.
Why is my Viper alarm not working?
If the procedure mentioned above does not work simply turn the key off then back on and press the valet switch two times. If this does not work turn the key off then back on and try it three times. Continue this up to five and one of them should disarm the alarm.
How do I reset my alarm after changing the battery?
Enter your access code on any console or keypad of the alarm system. Press the “Home” or “Away” button to arm the system, then immediately enter your access code and press “Off.” This action will reset the alarm to illuminate the low-battery signal to the system.
Where is the valet button on a Viper alarm?
Enable Valet Mode It is a small, black, momentary button that is usually mounted in an accessible, but not obvious location towards the bottom of the driver’s side dash. A common location would be on the driver’s kick panel cover, or on the side of the center console (if the vehicle has one).
How do I get my car out of valet mode?
How to Exit Valet Mode
- Insert your vehicle’s key into the ignition and turn to the “ON/RUN” position. Do not crank the engine.
- Press and release the LOCK and TRUNK buttons (I & III) simultaneously.
- Remove the key from the ignition and attempt to remote start your vehicle.
How do I reset my Viper car alarm after changing battery?
How do I reset my Viper alarm after changing the battery?
- Point the fob key toward your vehicle as the alarm sounds.
- Listen and wait for your alarm to sound for six seconds. Press the lock button on your key. Your vehicle’s Viper alarm will reset but the alarm will still be armed.
How do you reset a car alarm?
Resetting a Factory Car Alarm Unlock the car manually. Turn on your car. Utilize common tricks. Disconnect the battery. Reset the alarm unit. Remove the alarm fuse. Press the “panic” or buttons on your keychain remote to stop the alarm. Seek a mechanic if problems persist.
How do you program a Viper car alarm remote?
Step 1 Place your key in your car’s ignition and turn the key to the “On” position. Press and hold the “Program” switch on your car’s alarm transmitter. Press any button on your car remote while you are holding the “Program” switch and release both buttons. Press the “Program” switch on the Viper alarm’s transmitter once more and release it.
What is a Viper car alarm?
Viper is a car alarm system stuffed with top-of-the-line security, but more affordable brands like Avital and Python have similar protection alongside convenient features you’ll appreciate.