How do I reset my Subaru lights?
How to Reset a Subaru Check Engine Light
- Open the hood of your Subaru and loosen the nut that holds the cable clamp to the negative battery terminal.
- Slide the cable off the negative battery terminal.
- Wait 5 minutes, then reconnect the cable and tighten the retaining nut.
How do you reset the maintenance light on a 2013 Subaru Outback?
How to Reset Oil Maintenance Light Subaru XV For Model Year 2013-2015:
- Turn the ignition switch to the ON position.
- Pull and hold the “i/SET” switch toward you to show the selection screen.
- Use the UP/DOWN buttons to highlight the :Maintenance” item.
- Then pull the “i/SET” switch toward you.
How to turn on dash lights in Subaru Forester?
Warm up the engine (Engines warm – i had driven it for about 30 minutes before this) 2. Turn the ignition switch OFF (Went onto side of road – put it in park, turned off car, removed key) 3. Turn the ignition switch ON (Waited 5 seconds, then put key in and turned on ignition so dash lights up)
What makes the temp light flashing on a Subaru Forester?
Short or disconnection in engine torque control signal circuit 31 Throttle sensor. Short or disconnection in input circuit 32 Vehicle speed sensor 1. No signal input to speed sensor 1 above 20km/h 33 Vehicle speed sensor 2. No signal input to speed Sensor 2 above 20km/h 34 Turbine sensor.
What are the sensors on a Subaru Forester?
27 ATF temperature sensor. Detects open or shorted input signal circuit. 31 Throttle position sensor. Detects open or shorted input signal circuit. 33 Front vehicle speed sensor. Detects open or shorted input signal circuit. 36 Torque converter turbine speed sensor. Detects open or shorted input signal circuit. 38 Torque control signal.
What is the solenoid on a Subaru Forester?
73 Low clutch timing solenoid. Detects open or shorted output signal circuit. 74 2-4 brake timing solenoid. Detects open or shorted output signal circuit. 75 Line pressure duty solenoid. Detects open or shorted output signal circuit.