How do I reset my Dell PowerConnect 2808?

How do I reset my Dell PowerConnect 2808?

The Power Connect 2808 does not have a serial port. If you are unable to access the switch, use the Management Mode pinhole button to change the switch to unmanaged mode and then back to managed mode to reset the default settings.

How do I access Dell managed switch?

To access the switch’s management, perform the following steps:

1. Connect a personal computer to any of the Ethernet ports on the switch.
2. Assign the personal computer an IP address 192.168. 2.10 and subnet mask 255.255.
3. Open up a web browser and type in 192.168.
4. Log in with username admin and a blank password.

How do I reset my Dell n2048p?

Restore Dell N2024 or N2048 Switch to factory defaults

1. Manually reboot your switch.
2. While the switch is booting up keep an eye on the bootup screen and find “Dell Networking Boot Options” and select option #2 (Display Boot Menu) within 3 seconds.
3. On Boot Main Menu, enter choice # 10 for enable password removal.

How do I setup my Dell PowerConnect switch?

Connecting to the Switch From a Web Browser

1. Launch your Web browser.
2. In the Address bar, type .192.168.0.1.
3. If password protection is enabled on the switch, type root as the user and type the password that is assigned to the switch.
4. In the Main Menu, configure the PowerConnect settings.

How do I login to a managed switch?

Open a web browser. Type the IP address of the switch into the address bar of the web browser and press Enter. Type the admin password of the switch (the default password is password) and click Login.

How do I set up a Dell managed switch?

How to: Configure Dell switches for managed mode

1. Step 1: Setup your machine for IP address 192.168. 2.2.
2. Step 2: Set switch for managed mode. Using a paperclip, push in the little inset button for a few seconds until the Managed Mode light comes on, then release.
3. Step 3: Open the switches EWS.
4. Step 4: Make your changes.

How do I do a factory reset on a laptop?

Navigate to Settings > Update & Security > Recovery. You should see a title that says “Reset this PC.” Click Get Started. You can either select Keep My Files or Remove Everything. The former resets your options to default and removes uninstalled apps, like browsers, but keeps your data intact.

How do I change the admin password on my Dell switch?

Article Content

1. Open the Dell OpenManage Switch Administrator web interface by entering the IP address of the switch in your web browser.
2. Navigate through: System > Management Security > Enable Password.
3. Enter a new Enable password and click Apply.

How do I reset my HP Procurve 2824 to factory settings?

erase startup-config command from the console command prompt. buttons on the front of the switch. Continue to press the Clear button while releasing the Reset button. When the Test LED begins to blink, release the Clear button.