How do I know if my ice maker solenoid is bad?
Touch the probes to each terminal on the solenoid coil (Fig. 4). The meter should read in the range of 200 to 500 ohms. If the meter needle does not move, the coil is bad.
How do I unclog my ice maker?
Apply heat with a hairdryer to the ice maker fill tube, which is usually a white, rubber-like hose. Hold the nozzle of the hairdryer at the front of the ice maker so that the heat will blast into the fill line. Set the hairdryer to its lowest heat setting to avoid melting the plastic lines and parts of the ice maker.
How do I test my ice maker solenoid?
Attach the two multimeter probes to each solenoid contact. Read the multimeter’s display. A properly working solenoid will reflect a 200 to 500 ohm reading. Replace the solenoid if it produces no reading or has a large displayed value.
How do you turn on a norcold ice maker?
If your freezer compartment is not getting down to temperature, the ice maker will not cycle on. The other important thing to know is that it has an operating lever on the top. This bar, or lever, is in the OFF position when it is facing UP. Pull to the right until it clicks DOWN in order to turn it ON.
What causes an ice maker to stop working?
Common Ice Maker Problems. An ice maker can stop working for a variety of reasons. Ice makers receive water through a small water supply line that runs from the refrigerator to a water pipe, funnel, or a water filter. The most common reasons for ice maker problems are: Pause feature enabled. Water line malfunction or setting.
When to call for an ice maker repair?
Once power is restored and the water line is turned on, you should be able to hear the water running into the ice maker after thawing. If you don’t hear water running or the water is discolored, it’s time to make a call for an ice maker repair service.
What to do if your ice maker is leaking?
Perhaps your ice maker is making ice but it’s leaking water in the freezer or leaking onto the floor. Check your refrigerator and make sure it’s perfectly level Check your ice maker unit and make sure it’s level Check the water supply line for damage, pinching, or kinks