How do I get my motorcycle ready for spring?
These DIY motorcycle tips can get your bike ready for spring and get you on the road for a smooth highway cruise.
- Check for Small Animals and Debris.
- Drain the Gas Tank.
- Treat Gasoline with Fuel Stabilizer.
- Change the Oil.
- Check All Fluids.
- Inspect Battery.
- Check Electrical System.
- Brighten the Headlights.
What do you do when your motorcycle is out of storage?
Make sure your tire wear, inflation levels, and general health are ready for the road. Check your chain for slackness or rust spots. clean the chain and re-oil it with the bike on a stand. IMPORTANT*** Don’t just take off after your thorough inspection.
How do I start my bike after one year?
First start: Modern bikes need minimal or no throttle to rise from a cold start. But be patient when you start it after a long time, the engine may need to crank over a few times before it fires up. Once running, let it warm up for a few minutes and keep an eye out for any leaks.
How to prepare your bicycle for spring-DIY bike repair?
The length of your brake pads should press against your rim when activated, and they should not wiggle or be loose. Replace worn brake pads immediately and adjust the cable if they are too far from the rim. Use a bike stand or prop your bike upside down and run it through the gears as you are spinning the pedals.
When to replace brake cable on a bike?
A frayed or sticky cable should be replaced with a new brake cable. The length of your brake pads should press against your rim when activated, and they should not wiggle or be loose. Replace worn brake pads immediately and adjust the cable if they are too far from the rim.
What kind of maintenance should I do on my bike?
Obvious issues like flat tires, broken seats, and bent rims will require repair, but general maintenance should only take a few minutes. First you’ll want to give your bike a good washing by simply hosing it down to remove dirt and mud.
The length of your brake pads should press against your rim when activated, and they should not wiggle or be loose. Replace worn brake pads immediately and adjust the cable if they are too far from the rim. Use a bike stand or prop your bike upside down and run it through the gears as you are spinning the pedals.
A frayed or sticky cable should be replaced with a new brake cable. The length of your brake pads should press against your rim when activated, and they should not wiggle or be loose. Replace worn brake pads immediately and adjust the cable if they are too far from the rim.
Obvious issues like flat tires, broken seats, and bent rims will require repair, but general maintenance should only take a few minutes. First you’ll want to give your bike a good washing by simply hosing it down to remove dirt and mud.