How do I fix HL error on hot tub?
HL Error
- Turn the power off at the breaker for 15 seconds and then flip it back on. This will reset the HL reading.
- You will notice the display show some numbers.
- If you see the HL come back within a day or so, this means that there is likely a problem with the probe or the motherboard.
Is there a reset button on a hot tub?
There are generally two “hard resets” in hot tubs, the GFCI, and the high limit reset. The GFCI pops if there is any type of electrical short (such as water getting into the heating element, the reset on that can be in one of three places.
How do you test a hot tub high limit sensor?
Testing Spa Temperature Sensors
- Shut off all power to the spa at the breaker and spa pack.
- Set your Ohm meter to the 20K setting.
- Locate the wire ends and remove the plug from the board.
- Place your meter leads onto the green and red wire.
- Compare readings to Thermistor Resistance vs. Temperature Chart.
How do I reset my CleverSpa HL?
Reset the hot tub by pressing the ‘Off/Test’ button on the RCD plug. a. Wait 10 seconds then press ‘On/Reset’ to turn it back on again.
What does a high limit sensor do?
Sometimes also called a hot tub high limit sensor or simply a high limit sensor, this is a safety feature built into all hot tubs that prevents them from overheating. It keeps the temperature from exceeding 120°F (49°C) in most cases.
Where is the high limit reset button?
The High Limit Reset Button is located behind the gas valve.
Where is the high limit switch on my hot springs hot tub?
A limit switch will be located in your heater enclosure, mostly in its lower-left corner. It is usually white in color with a red button at the center. If your water is not heating up and you think the heater is the problem, one heater element that you need to check out will be the limit switch.
How do I fix HL error on CleverSpa?
An HL error usually means there is a blockage, preventing water from circulating around the pump & heating system….
- Turn off the heater.
- Remove the Filter sock and Filter.
- Place the filter sock over the filter inlet.