How do I find my cel code?
Follow these 4 steps to insert and read the OBD scanner:
- Step 1: Locate your vehicle’s OBD port.
- Step 2: Plug your OBD scan tool into the connector.
- Step 3: Read the codes in the computer.
- Step 4: Record the codes that display.
- Step 2: Determine the meaning of the letter.
Where to find Nissan check engine light codes?
These are listed in numerical order for easy searching. When retrieving Nissan check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
What is the trouble code for a 1996 Nissan?
Trouble Code Info Model Year Engine identification System 200SX 1.6L 1996-98 GA16DE Nissan EGGS 200SX 2.0L 1996-98 SR20DE Nissan ECCS 240SX 2.4L 1996-98 KA24DE Nissan ECCS 300ZX 3.0L 1996 VG30DE Nissan EGGS
How to clear engine codes without a Nissan consult or scan tool?
How to clear the engine codes without a Nissan CONSULT or scan tool. Set ECM in Diagnostic Test Mode II (Self-diagnostic results). Fully depress the accelerator pedal and keep it for more than 10 seconds. The emission-related diagnostic information has been erased from the backup memory in the ECM.
Where is the Diagnostic Code on Nissan overheat warning lamp?
Check that Overheat Warning Lamp is displaying Diagnostic Display Code. Connect memory clear connector 2400400Z09, or a suitable jumper wire to reset switch terminals. The reset switch is located behind the electrical unit board. Check that Overheat Warning Lamp and Buzzer display shows Diagnostic Display Code 0–1.
These are listed in numerical order for easy searching. When retrieving Nissan check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
How to clear the engine codes without a Nissan CONSULT or scan tool. Set ECM in Diagnostic Test Mode II (Self-diagnostic results). Fully depress the accelerator pedal and keep it for more than 10 seconds. The emission-related diagnostic information has been erased from the backup memory in the ECM.
Check that Overheat Warning Lamp is displaying Diagnostic Display Code. Connect memory clear connector 2400400Z09, or a suitable jumper wire to reset switch terminals. The reset switch is located behind the electrical unit board. Check that Overheat Warning Lamp and Buzzer display shows Diagnostic Display Code 0–1.