How do I align my Jeep headlights?
Jeep headlights have two adjustment screws, one at the top to adjust the vertical direction and one on the side to adjust the horizontal direction. Pull your Jeep as close as possible to the flat surface/garage door and turn your headlights on.
Where to adjust the headlight beam on a jeep?
The top of the brightest part of your headlight beam should be right at the center of your plus marking, or just below. If that is not the case, grab your torx screwdriver, locate your vertical adjustment screw, and adjust either clockwise or counter-clockwise, depending on the direction you need the beam to move.
How do you adjust the light on a Jeep Wrangler?
The small adjustment bolt can be turned with a T15 torx. Turning the adjustment bolt to the LEFT LOWERS the light beam. RIGHT RAISES the light beam. With the ideal light height marked on the wall, we need to adjust the height of the light projected by the headlights.
How long does it take to replace headlight on Jeep Wrangler?
Overall doing a Jeep headlight replacement yourself is a straight forward task, that beginners can do in about an hour or less. Try to find an area with level ground that has a flat wall and over 35 feet of clear space. Most long driveways could work but you have to be conscious of any level changes.
What’s the best way to adjust your headlights?
Then, grab some masking tape and find a garage or wall (white or similar light colors are preferred) where you can park and aim your headlights from about 20 to 30 feet away away. It is important that this area is flat. Parking on a hill will cause incorrect alignment of your headlights.
How do you adjust headlights on a jeep?
When lifting Jeeps the headlights are often over looked so use this simple guide to adjust your headlights aiming pionts. Step 1 – On level ground, put your Jeep vehicle in front of a wall as close as possible. Step 2 – With tape, put 2 crosses on the wall that correspond with the vertical and horizontal center lines of both headlights.
Where are the screws on a jeep headlight?
Find the little indentations on the chrome bezels located at the 4 and 10 o’clock positions around the bezel, those give clearance for access to the two adjustment screws. They both aim the headlight so it’s a little of both to move it in the direction it needs to go. Top screw for up-down, bottom screw for left-right.
What’s the best way to align your headlights?
Step 3 – Move the Jeep back 25 ft., keeping the Jeep centered with the tape crosses on the wall. Step 4 – Examine the light pattern. Low Beams should be hitting the lower right sections of the crosses. High Beams should split the cross hairs. Turn the horizontal and vertical adjusting screws (located on the headlights bucket) to make adjustments.
Can you adjust the LEDs on a Jeep Wrangler?
LEDs do not have that filament issue yo be adjusted for. That’s how you adjust them. But let’s talk about headlight themselves.