Does the Nissan 240SX have a bad O2 sensor?
– Does my 240sx have a bad O2 sensor? – What Can My KAT Handle In Stock Form? – Front-End Conversions: What do I need? – Water leaking into hatch? – So you want to autocross? – My RB is overheating!
What causes a Nissan 2.4L fuel injector to fail?
Fuel Injector Tutorial Summary. More Nissan 2.4L Test Articles. In my experience, the three major causes of a fuel injector fault/problem are: Fuel injector doesn’t spray any fuel. Fuel injector sprays fuel, but not enough (clogged fuel injector).
What happens when a fuel injector goes bad?
What really stinks about having a fuel injector go bad, or get clogged, or stay stuck On all of the time, is that the PCM (Powertrain Control Module = Fuel Injection Computer) doesn’t set a specific fuel injector malfunction trouble code.
How do you test a Nissan fuel injector?
To get started, you need to disconnect all 4 fuel injectors from their electrical connectors. Once all of the fuel injectors are disconnected, test the resistance of each one with your multimeter in Ohms mode. You’ll do this by probing the male spade terminals inside the fuel injector with the multimeter’s test leads.
What kind of fuel pump does a Nissan 240SX use?
The 240SX used a thermal type fast idle valve that just needs to be supplied with 12 volt power when the engine is turned on; the fuel pump relay can drive this (and does in Nissan’s factory wiring arrangement).
Can a Nissan 240SX be run without MegaSquirt?
The valve Nissan refers to as the “Air Regulator” will open on its own, so you do not need to set up any sort of idle control with Megasquirt. However, there’s two other fast idle valves on there. One is an on/off valve that opens when the air conditioning is on, which also could be run without the MS. Nissan calls this the FICD valve.
When did Nissan change the wiring on the 240SX?
The specifics of the input wiring will depend on which year 240 you have; Nissan changed the wiring colors in 1991. However, the wires serve the same purpose; only the colors changed.
What should the spark settings be on a Nissan 240SX?
On the ‘Spark’ menu choose ‘Spark Settings’ and set ‘Spark Output Inverted’ to NO when driving the stock power transistor. It is critical to get the Spark Output Inverted setting correct, as setting this wrong can result in damage to the power transistor. Dwell settings will depend on the coil used.
Which is the largest Nissan 240SX Forum in the world?
Last post Re: New Member from Florida -… Founded in 1997, the first and largest Nissan 240sx forum on the web. Anything else is a cheap knockoff. A forum for modern (1984-present) Z cars, including 300ZX, 350Z and 370Z (Z31 through Z35 chassis).
What should I do if my ignition switch is not working?
Keep pressing it in until you hear the click of the release pin setting into place inside the steering column. If you don’t hear a click from the release pin, the ignition switch isn’t properly seated yet. You may need to push in on the switch a little to make it click into place. Helpful? Reconnect the battery and test the new switch.
What does a negative ignition switch look like?
It will look like a black box with a positive (+) and negative (-) post sticking out of the top of it. Use an appropriate sized wrench to loosen the nut holding the cable on the negative (-) terminal and then slide it off the post. You don’t need to remove the positive cable from its terminal.