Does the 2004 Honda Accord have a fuel filter?
It’s in the fuel tank and is designed to be “lifetime”.
Where is the fuel filter located on a Honda Accord?
The fuel filter location is different on certain model years. 1990-1994: Accord fuel filters are located on the passenger’s side firewall. 1995-2002: Accord fuel filters are located on the rear of the engine, near the brake master cylinder.
What to do if you spill gas on your Honda Accord?
Place the fluid catch pan under this area to catch any spilled gas. Once the nut is removed, pull the lower fuel line off and set it aside. Then, use the 17 mm flare nut wrench to loosen the Banjo bolt on upper fuel line.
How do you change the fuel line on a Honda Accord?
Place the fluid catch pan under this area to catch any spilled gas. Once the nut is removed, pull the lower fuel line off and set it aside. Then, use the 17 mm flare nut wrench to loosen the Banjo bolt on upper fuel line. Rotate the wrench counterclockwise to loosen the bolt, and then remove the fuel line by hand.
How do you replace a fuel filter clamp?
Unclip the alignment hole holding the top of the fuel filter in place, and then remove the fuel filter from the clamp. Dispose of the old filter and place the new fuel filter in the clamp. Then, insert the fuel filter clamp to its original location and secure it with the two 10 mm bolts. Figure 6. Remove and replace the fuel filter from the clamp.
The fuel filter location is different on certain model years. 1990-1994: Accord fuel filters are located on the passenger’s side firewall. 1995-2002: Accord fuel filters are located on the rear of the engine, near the brake master cylinder.
Place the fluid catch pan under this area to catch any spilled gas. Once the nut is removed, pull the lower fuel line off and set it aside. Then, use the 17 mm flare nut wrench to loosen the Banjo bolt on upper fuel line.
Place the fluid catch pan under this area to catch any spilled gas. Once the nut is removed, pull the lower fuel line off and set it aside. Then, use the 17 mm flare nut wrench to loosen the Banjo bolt on upper fuel line. Rotate the wrench counterclockwise to loosen the bolt, and then remove the fuel line by hand.
Unclip the alignment hole holding the top of the fuel filter in place, and then remove the fuel filter from the clamp. Dispose of the old filter and place the new fuel filter in the clamp. Then, insert the fuel filter clamp to its original location and secure it with the two 10 mm bolts. Figure 6. Remove and replace the fuel filter from the clamp.