Does MSD Ignition need a ballast resistor?
Basically you need to have a ballast resistor on your setup thats why MSD has it in there instructions. The resistor is so you dont blow up the coil when the power is on. Doesnt matter points or electronic. Yes points need a little more resistance so there resistor has more ohms.
How to install a MSD ready to run distributor?
Remove the MSD Ready to Run distributor and accessories from the box. Install the new MSD distributor gasket and apply a liberal amount of the supplied lubricant to the distributor gear.
What kind of distributor do I need for AMC V8?
GM HEI distributor for an AMC V8. Most Jeeps with V8 engines have one of two distributor systems. A Ford Duraspark system or a Motorcraft points system. The points system is relatively reliable and very simple. It requires periodic adjustment and maintenance using special tools.
How are curve changes made on a MSD distributor?
Curve changes in the distributor are made by way of springs. Weights are not changed (which was common in the old days with factory distributors). MSD includes a wide range of springs with their distributors. The ignition trigger is magnetic and it includes a precision reluctor wheel.
How do you change the distributor on a jeep?
Look down at the timing cover marking and line up the line on the harmonic balancer to the 0 line on the cover. BE CAREFUL – Watch out for the fan and make sure the Jeep is in neutral! Remove the bolt and bracket that holds the distributor in and pull it out.
Look down at the timing cover marking and line up the line on the harmonic balancer to the 0 line on the cover. BE CAREFUL – Watch out for the fan and make sure the Jeep is in neutral! Remove the bolt and bracket that holds the distributor in and pull it out.
GM HEI distributor for an AMC V8. Most Jeeps with V8 engines have one of two distributor systems. A Ford Duraspark system or a Motorcraft points system. The points system is relatively reliable and very simple. It requires periodic adjustment and maintenance using special tools.
What kind of distributor does a jeep V8 have?
Most Jeeps with V8 engines have one of two distributor systems. A Ford Duraspark system or a Motorcraft points system. The points system is relatively reliable and very simple. It requires periodic adjustment and maintenance using special tools. The Ford Duraspark system is all electronic.
Why do I need to change the timing on my AMC 304?
As part of the tuneup procedure, you can adjust the timing on the 304 to synchronize the spark produced by the ignition coil with the pistons during their four-stroke cycle. This is necessary to prevent spark knock, preserve fuel economy and engine performance.