Do you need to replace the O-ring in coolant tube?
DID ANYONE NEEDED TO REPLACE THE O-RING IN THE COOLANT TUBE AFTER THEY DID A EGR COOLER DELETE? HAD NOTTICE COOLANT UNDER THE TRUCK FOR FEW DAYS NOW AND WAS THINKING IT WAS MY WATER PUMP DUE TO THE BIG RECALL.
Where does the O-ring go in a delete kit?
COULDN’T FINE THE LEAK..NO WET SPOTS FOUND AROUND THE WATER PUMP AREA..THEN I HAD NOTTICE RIGHT UNDER THE COOLANT TUBE WAS SOME WET SPOTS..PIN POINT THE PROBLEM THAT WAS THE O-RING IN THE DELETE KIT THAT GOES IN THE STOCK COOLANT TUBE MUST GONE BAD. CONTACTED SINISTER DIESEL FOR SOME NEW O-RING..DID ANYONE HAVE THIS PROBLEM??
What to do when your coolant hose starts to leak?
The bracket will sometimes move causing the connector piece to move slightly and pinch the o-ring. After that it’s only time that it will start to leak. Most people go for the molded coolant hose from GDP. If you take that o-ring and go to a parts store you can get it replaced as it’s a regular o ring.
What causes coolant to leak from the intake manifold?
Over time heat and corrosion with cause the gasket to leak internally in most cases either pushing exhaust into the cooling system or allowing coolant to leak inside of the engine. There are several tests that can be used to determine if the head gasket has failed in which case the gasket should be replaced. 9. Intake Manifold Gasket Leak
DID ANYONE NEEDED TO REPLACE THE O-RING IN THE COOLANT TUBE AFTER THEY DID A EGR COOLER DELETE? HAD NOTTICE COOLANT UNDER THE TRUCK FOR FEW DAYS NOW AND WAS THINKING IT WAS MY WATER PUMP DUE TO THE BIG RECALL.
COULDN’T FINE THE LEAK..NO WET SPOTS FOUND AROUND THE WATER PUMP AREA..THEN I HAD NOTTICE RIGHT UNDER THE COOLANT TUBE WAS SOME WET SPOTS..PIN POINT THE PROBLEM THAT WAS THE O-RING IN THE DELETE KIT THAT GOES IN THE STOCK COOLANT TUBE MUST GONE BAD. CONTACTED SINISTER DIESEL FOR SOME NEW O-RING..DID ANYONE HAVE THIS PROBLEM??
The bracket will sometimes move causing the connector piece to move slightly and pinch the o-ring. After that it’s only time that it will start to leak. Most people go for the molded coolant hose from GDP. If you take that o-ring and go to a parts store you can get it replaced as it’s a regular o ring.
Why does my igotacummins coolant hose keep leaking?
This is definitely a common problem with that kit. The bracket will sometimes move causing the connector piece to move slightly and pinch the o-ring. After that it’s only time that it will start to leak. Most people go for the molded coolant hose from GDP.
How often should the oil filter be replaced on a Cummins N14?
It is recommended that the oil filter, fuel filter and coolant filters all be replaced every 11,500 miles. The N-14 does not do well with cheaper filters that don’t further remove particulate matter.
When did Cummins come out with the N14 engine?
First designed in the late 1980s it was sent into full production in 1991. The N14 engine is the follow up to the vastly popular Cummins 855 Big Cam which was produced 1976-1985. Cummins listened to it customers and designed a more powerful version of the 855 while maintaining a similar profile and bore/stroke architecture.