Do you have to remove timing belt to remove head?
Yes. Just loosen the tensioner bolt, push it aside, re tighten it to lock it in the loose position. It may be a pain to line everything up again if the belt drops down a bit. You may he better off removing the timing cover.
Do you have to clean engine before replacing timing chain?
These two parts perform the same task, but replacing them can be quite different. This procedure is only for replacing a timing chain. Clean the engine with the proper degreaser thoroughly before beginning. Having your engine clean allows you to better locate any leaks or worn parts. It also makes the job less messy overall.
How are gears connected to the timing chain?
Locate marks on your crankshaft and camshaft gears. These gears are connected by the timing chain so that the position of the piston (connected to the crankshaft) correlates directly to the opening of the fuel and exhaust valves (operated by the camshaft) to keep your engine running smoothly.
What are the bright links on a timing chain?
Locate marks or “bright” links in your timing chain. These links are brighter than the other links and are used to align your engine. Set your engine to top dead center. To get your engine to top dead center, line the bright links on the timing chain up with the marks on your camshaft and crankshaft gears.
How do you change the timing chain on a water pump?
Remove the belt. Once tension is released, the belt should slide off of the other pulleys easily. Remove the heater hoses from the water pump. If your model has heater hoses attached to the water pump, loosen the hose clamps with a screwdriver and slide them back onto the hose. Wiggle the hose and pull it off of the water pump.
When to go to the Mechanic about a bad timing chain?
If the belt is jumping because it’s gotten loose, it can also flail around and damage other parts of the engine. If your engine won’t start or starts driving rough, indicating it may be on its way to failing, contact a certified mechanic for inspection and repairs. 4. Check Engine Light is on
What causes oil to separate from the timing chain?
Over time, oil begins to separate as it heats up and is exposed to natural solvents found in gasoline. If the timing chain begins to wear out, small metal pieces can break off the chain and find their way into the oil pan.
What does it mean to re-install timing chain?
Which means to align the crank timing marks and the cam timing marks to spec, then re-install the timing chain. Before moving the cam or crank, find a copy of the manufacturer’s procedure on how to do this without banging the valves into the piston or the valves into the valves. The method varies engine to engine.
Where can I find the timing chain procedure?
You can also find step-by-step instructions at www.Autozone.com, setting up an account, and using their repair guides. I just checked, and your ’87 2.4L Z24 engine timing chain procedure is in there. It is slightly involved, so I don’t want to try and retype them here and make a mistake.