Can you upgrade a Dana 35?
There are two options when upgrading the 35 shafts. Superior Axle & Gear offers its Super 35 kit and Warn has a full-float kit. The Super 35 kit is available for both C-clip and non-C-clip axles. The kit replaces the smallish shafts with 1.31-inch 30-spline pieces that are over 35 percent stronger than stock.
What is the axle diameter of a Dana 35?
Axle Shaft diameter Rear 1.09 inches (28 mm) (30 Spline) Ring and Pinion gear sets for Jeep Dana 35 rear applications can be used in Ford Ranger IFS (Dana 35) front axles.
Can a jeep Dana 35 be used in a Ford Ranger?
Ring and Pinion gear sets for Jeep Dana 35 rear applications can be used in Ford Ranger IFS (Dana 35) front axles. http://www.4wheelparts.com lists the Spicer gear sets for both versions of this axle as the same part number. Throughout the 1990s Ford used the Dana 35 as a front axle in both TTB and full IFS variations.
What kind of axle does a jeep Dana use?
The Dana 35 is used extensively in the Jeep models. This axle had a GAWR up to 2700 lbs. There were many ratios offered over the lifetime of the Dana 35/AMC 15. 35c is a little bit newer version of dana35. C stands for a Custom as the axle was delivered to the end user without axle brackets.
When did Ford start using the Dana 35?
Throughout the 1990s Ford used the Dana 35 as a front axle in both TTB and full IFS variations. These units also follow Ford’s tradition of using high pinion, reverse cut units.
What’s the difference between Dana 30 and Dana 35 axles?
The Dana 30 gear ratios are either 3.21 or 3.73. The width of the axle shafts is 1.13 inches. The YJ Dana 30 hold a reverse cut ring and pinion, but the TJs do not. Both TJs and YJs, however, use a 5×4.5 inch bolt pattern. Dana 35: This was an axle size used on most Jeep rear axles. They had a ring gear diameter of 7 and 9/16 inches.
What kind of rear axle does a Jeep Wrangler TJ have?
Crown Automotive 5103015AA Driver Side Rear Axle Shaft for 03-06 Jeep Wrangler TJ with Dana 35 Rear Axle Without ABS – Fits Tag # 52111766AF or 52104676AC Only!
What’s the difference between Dana and JK Rubicon axles?
JK Rubicon models have a thicker, slightly redesigned 44. This Rubicon axle is referred to as a Super Dana 44. Dana 44 – For TJs, the inner and outer axle has 30 splines. JK Rubicon model front axles have 30 inner splines and 32 outer splines.
What kind of axle does a Wrangler Rubicon have?
Rubicon models come standard with a 4.10 rear gear ratio and also use a Dana 44 axle in the front with either a 3.73 or 4.10 gear ratio. The width of the axle shafts is 1.31 inches.