Can you change the spark plugs on a Porsche 993?
Changing your spark plug wires is one of the more difficult jobs, but you can do it in your own garage. Here’s how it’s done. This article applies to the Porsche 993 (1993-1998). Keep your 993 engine running smoothly and clean by keeping up with regular maintenance and changing out components when they start to go bad.
How do you remove exhaust tips on a Porsche 993?
Remove the exhaust tips using a pair of 13mm wrenches. With the fastener removed, spread the clamp using a small pry bar or pliers and remove the tip. With the tips removed, undo the 13mm fasteners securing the mufflers to the catalytic converter. Spread the clamps in the same way as done on the exhaust tips.
Where is the air box on a Porsche 993?
Rotate toward the top of the car and the air box will come free. There is a black hose, about 1.5 inches in diameter, on the back of the air box between the number four and five runners; disconnect this at both ends, remove the air box, and set it to the side. Figure 3. Removing the air box is a necessary step, giving you the room you need to work.
Where can I get new spark plug wires?
The replacement plug wires from STI are a popular choice because they come with all the brackets and grommets pre-installed. There is no transfer necessary of these parts from old to new. Immediately after removing your cables from the plastic bags, label them.
Changing your spark plug wires is one of the more difficult jobs, but you can do it in your own garage. Here’s how it’s done. This article applies to the Porsche 993 (1993-1998). Keep your 993 engine running smoothly and clean by keeping up with regular maintenance and changing out components when they start to go bad.
What kind of wiring does a Porsche 928 use?
These high quality ignition wires fit the factory wiring clips exactly, and have genuine Beru™ connector ends on them – not imitations! Made with platinum-cured 7mm silicone over a tough fiber braid core. PLUS: Every wire is wrapped with the correct cylinder number for easy installation!
Remove the exhaust tips using a pair of 13mm wrenches. With the fastener removed, spread the clamp using a small pry bar or pliers and remove the tip. With the tips removed, undo the 13mm fasteners securing the mufflers to the catalytic converter. Spread the clamps in the same way as done on the exhaust tips.
Rotate toward the top of the car and the air box will come free. There is a black hose, about 1.5 inches in diameter, on the back of the air box between the number four and five runners; disconnect this at both ends, remove the air box, and set it to the side. Figure 3. Removing the air box is a necessary step, giving you the room you need to work.