Can a torque converter be incorrectly installed in a transmission?
Replacing the torque converter in this transmission is simple but it is very common for mechanics to incorrectly install it. Incorrect installation leads to immediate failure of the fluid pump upon start up and requires the transmission to once again be removed for repairs.
How to install torque converter in 4L60E transmission?
Hold on to the converter by its sides, primarily at 3 o’clock and 9 o’clock positions. Gently pull it back towards you and slowly rotate in a rocking motion by moving your hands up and down a few inches as if you were turning a steering wheel.
How do you drain a torque converter in a car?
Hold on to the converter by its sides, primarily at 3 o’clock and 9 o’clock positions. Gently pull it back towards you and slowly rotate in a rocking motion by moving your hands up and down a few inches as if you were turning a steering wheel. Drain the torque converter of old fluid. The torque converter will contain a few quarts of fluid.
What should I do if my automatic transmission fails?
If they fail or short out, shift patterns can change or leave the transmission in second or third gear as a default setting. Drive the vehicle using a slow, gradual acceleration. Feel and listen for each individual automatic shift.
How do you install a torque converter on a transmission?
When ready to insert on the input shaft, turn the converter vertically with the bolt holes facing towards you. Hold the torque converter by its sides at 3 and 9 o’clock and slide onto the input shaft while slowly rotating it back and forth, as in Step 2, until you hear the first “clunk.”
Where is the auto transmission on a 1999 Nissan?
Remove the crankshaft position sensor. It is located on the top driver’s side of the bell housing. 3. Remove exhaust tubes from the catalytic converters all the way back. 4. Unbolt and remove the fluid change pipe from the engine and transmission. In order for the fluid change pipe to clear the engine completely remove the automatic transmission.
What causes transmission fluid to leak out of torque converter?
A faulty seal of the torque converter will cause the transmission fluid to leak out of the torque converter, and thus the pressure inside the converter will be lost. Low pressure inside the torque converter will cause slippage, overheating, and other strange symptoms.
Why are the bearings in my torque converter worn out?
A widespread problem is that the bearings in the torque converters are worn. This does not cause slippage or other transmission problems but can cause bearing noises from the transmission. If you hear bearing noises from the transmission, check the transmission fluid, and see if you can see metal parts inside the transmission fluid.