Can a throttle by wire shut down a jeep?
On even newer Jeeps with Throttle by wire, it might shut down with a catastrophic throttle by wire (TBW) T-body motor error or TPS stuck open on all cars, preventing “Toyota Run-Aways” if you get my drift. (lawsuits…) FACT: In each case the PCM will log errors and show DTC errors, if you only LOOK!
Where are the O2 sensor fuses on a Jeep Wrangler?
3. Checked fuses, checked O2 sensor fuses including O2 sensor (Cali) ones. My jeep wasn’t made in Cali. so only the small fuses had to be checked. Checked also the PDC relay fuse behind the glove compartment.
What are the sensor codes for a Jeep Wrangler?
I own a 2000 Wrangler 4.0L sport, and recently got the (OBDII) P0132 & P0138 codes which are High Voltage Output in sensors 1 & 2. I had to search this forum, as well as other sites to make sure I was investing my money the right way . Anywayz here’s the breakdown: 1. Got the codes P0132 & P0138. 2.
What is the automatic shut down relay on a jeep?
ASD relay “Automatic Shut Down relay” used on all EFI jeeps. 1990 to present. What is it? It is a safety device, that exists by LAW and for good reasons. It CAN prevent FUEL fires (the Classic Crash and burn reason) and engine hyrdolocking.
Are there any problems with my Jeep Wrangler?
Drove Jeep for 10 miles and had ALL monitors (except Evap) go ready. Immediately went to the smog shop where it passed with flying colors. Yeah!!! Since the successful smog test I have driven about 400 miles with ZERO problems. In fact the engine runs much smoother now.
How many fuses are in a Jeep Wrangler?
1997-1998 № Amp Rating Description 2 40 Ignition Switch (Fuse (Passenger Compart 3 30 Ignition Switch (Cigar Lighter/Accessory 4 40 Passenger Compartment Fuse Block: “1”, ” 5 40 Cigar Lighter/Accessory Relay (Passenger
Are there any running / parking lights on my Jeep Wrangler?
Enter your ride HERE to be a part of JUNE’s Ride of the Month Challenge! right now it keeps blowing fuses when i turn on the running/parking lights. Head lights, turn signals and hazard lights all work fine. Here is what i have done so far.
How to check the injector signal on a Jeep Wrangler?
3) Swapped injectors #1 and #2. Drove Jeep with same result as above. 4) Used a NOID Light to check injector signal. All good. 5) Performed a dry compression tests on all cylinders, #1 was 125, about 10 below the next lowest, #3