Can a passenger seat be replaced in a Tesla?
The passenger seat was a direct swap. One wiring harness and the airbag connector. However, when I went to replace the driver’s seat, I recognized the newer seat had connectors that had been totally changed by Tesla and were not compatible with an older car.
How much does a power seat module cost?
The seat back return circuit — the first on the board — was typically the first sign of trouble. I looked for a new module, which had a Ford part number, and was quoted between $600 and $700. I dug deeper into the forum, and found the answer inside one of the many topical threads.
What happens if power seat module goes bad?
Nights coil into vortices of primal fear: transmission meltdown, air-suspension fault, full-on powertrain armageddon. You dream of wolves, vultures, a midterm you haven’t studied for. You imagine yourself as every person on that shotgun carousel from Saw VI .
What are the electronics in the front seat?
There is an electronics package for seat memory and control, seat heater, seat pressure detector along with an airbag in the side the seat towards the window. The seat memory controller also controls the steering wheel position motors. Seat versions often overlapped in time – where newer versions were available along with older versions.
What to use to repair seat control module?
You can also purchase self adhesive copper repair traces, or use a conductive paint pen. Sometimes it is easier to just solder a fine wire (28 or 20 ga. kynar insulated wire is typically used) between the endpoints of the components that have the broken trace between them than ty to repair the trace.
The passenger seat was a direct swap. One wiring harness and the airbag connector. However, when I went to replace the driver’s seat, I recognized the newer seat had connectors that had been totally changed by Tesla and were not compatible with an older car.
How do you repair a seat adjustment switch?
To repair the switch, you’ll need to need to remove the circuit board from inside the switch housing. Begin by prying the back cover off the switch. This is done by placing a small flat head screwdriver into the slots shown here (green arrows).
How do you replace seat adjustment switch on Pelican?
Slide the plastic locking tab to the side to release the harness from the module. Re-insert the harness into the module, slide the locking tab to secure the harness and turn the ignition on. Check if the switch works now.